Use and Care Manual

Assembly and adjustments (continued)

Adjustments

Align the belt pulleys (Fig. 16)

1. Check the alignment of the pulleys with a

straight edge (1) (such as a ruler, level, or

framing square) by laying the straight edge

across the top of the pulleys (2).

2. If the pulleys are not aligned, release belt

tension by loosening the belt tension lock knobs

(3) on both sides of the head.

3. Loosen the motor mount nuts (4) with an

adjustable wrench, and lower or raise the motor

until the pulleys are aligned.

4. Tighten the motor mount nuts (4) with an

adjustable wrench to maintain the position.

5. Lock the motor for the proper belt tension and

tighten the tension lock knobs (3).

Spindle speeds (Fig. 17)

This drill press offers 5 spindle speeds from 570 to 3050 RPM. The highest speed is obtained when

the belt is positioned on the largest motor pulley step and the smallest spindle pulley stop.