Use and Care Manual

ASSEMBLY AND ADJUSTMENTS

DRILL PRESS HEAD TO COLUMN (Fig. 6)

CAUTION: The drill press head is heavy. To avoid injury, two people

should lift it into position.

1. Carefully lift the drill press head assembly (1) and position it over the

column (2).

2. Place the mounting opening on the drill press head over the top of

the column. Make sure the drill press head is seated properly on the

column.

3. Align the direction of the drill press head with the direction of the

base and the table.

4. Tighten the set screws (3) using a hex key.

FEED HANDLES (Fig. 7)

1. Insert the three speed handles (1) into the threaded openings on the

feed hub (2).

2. Manually tighten the handles into the openings.

Note: When using the drill press, one or two of the feed handles may

be removed if an unusually-shaped workpiece interferes with handle

rotation.

SPEED HANDLE (Fig. 8)

1. Insert the feed handle (1) into the threaded opening on the speed

hub (2).

2. Manually tighten handle into opening.

Fig. 2

Fig. 3

Fig. 6

Fig. 7

Fig. 8