User Manual

ASSEMBLY AND ADJUSTMENTS

RAISE OR LOWER THE TABLE

1. Loosen the support lock handle (Fig. N - 2) and turn the crank handle (Fig.

N - 1) until the table is at the desired height.

2. Tighten the support lock handle (Fig. N - 2) before drilling.

ROTATE THE TABLE

1. Loosen the support lock handle (Fig. N - 2) and turn the table around the

column to the desired position.

Note: The rack should rotate around the column with the table support bracket.

If the rack binds and does not rotate, slightly loosen the set screw in the rack

collar.

2. Tighten the support lock before drilling.

TILT THE TABLE

1. Loosen the bevel lock bolt (under table) (Fig. O - 2) with a suitable socket

wrench.

2. Tilt the table to the desired angle, using the bevel scale (Fig. O - 1) as a basic

guide.

3. Re-tighten the bevel lock bolt (Fig. O - 2).

4. To return the table to its original horizontal position, loosen the bevel lock

bolt (Fig. O - 2). Realign the table to the 0° setting on the bevel scale and tighten

the bevel lock bolt with the wrench.

FEED DEPTH ADJUSTMENT

Turn the depth scale ring to the desired depth. Lock the scale ring in place us-

ing the depth adjustment knob (Fig. P - 1). The drill bit will stop after traveling

the distance selected on the depth scale.

Fig. J

Fig. N

Fig. O

Fig. P