User Manual

4214 WENPRODUCTS.COM

Assembly

and

adjustments

(continued)

WARNING: If any part is missing or damaged, do not plug the drill press in until the missing or

damaged part is repaired or replaced, and assembly is complete.

The column assembly (column, column support, rack,

rack collar, and table support bracket) must be

attached to the base. The table and table support

handles must be attached to the table support bracket.

The motor housing must be attached to the column.

Tools needed for assembly

• Adjustable wrench

• screwdriver

• Hammer and block of wood

Column assembly to base (Fig. 3)

1. Place the column tube (1) on the base (2),

aligning the column support holes to the base

holes.

2. Install a hex head bolt (3) in each column

support hole and tighten bolts using the

adjustable wrench.

Table to table support bracket (Fig. 4)

1. Loose rack collar hex screw M8X10.

2. Remove rack collar and rack from column.

3. Place rack (teeth up) in slot of table support.

4. Slide table support with rack in slot onto

column.

5. Slide rack collar down column onto beveled end

of rack and tighten rack collar hex screw

6. Place the crank handle (1) onto the shaft (2) of

the table bracket so the flat of the shaft is under

the set screw (3). Tighten the set screw.

7. Thread the table lock handle (4) into the

front of the table support bracket.

8. Thread the table support lock handle into

the rear of the table support bracket (not

shown).

9. Position the table (5) in the same direction as

the base, install the table, and tighten the table

lock handle (4).

Fig. 3

Fig. 4