Use and Care Manual

ASSEMBLY AND ADJUSTMENTS

UNPACKING

Unpack the drill press and all of its parts. Compare against the list below. Do not discard the carton or any pack-

aging until the drill press is completely assembled.

To protect the drill press from moisture, a protective coating has been applied to the machine’s surfaces. Remove

this coating with a soft cloth moistened with kerosene or WD-40®. Do not use acetone, gasoline, or lacquer thin-

ner to clean. Apply a coat of good paste wax to the table and column. Wipe all parts with a clean dry cloth.

Not Shown: Hex wrenches (3, 4, 5, 6 mm), hex bolt M10X30, pan head screw M4X10, socket head screw M8X12,

flat head screw M6X16

CONTENTS INCLUDE:

A - Head Assembly

B - Feed Handle

C - Hub Cover

D - Handle Cap

E - Column Assembly

F - Table Assembly

G - Table Locking Handle

H - Table Adjustment Crank

I - LED Light

J - Base

K - Chuck

L - Arbor

M - Chuck Tool

N - Chuck Key