User Manual

9
CARTON CONTENTS
UNPACKING AND CHECKING CONTENTS
This Bench Grinder will require a minimal amount of assembly.
1. Remove parts from all of the cartons and lay them on a clean work surface.
2. Remove any protective materials and coatings from all of the parts and the bench grinder. The protective
coatings can be removed by spraying WD-40 on them and wiping it off with a soft cloth. This may need to
be redone several times before all of the protective coatings are removed completely.
CAUTION: DO NOT use acetone, gasoline or lacquer thinner to remove any protective coatings.
3. Compare the items below; verify that all items are accounted for before discarding the shipping box. If
there are any missing parts, call Customer Helpline 1-800-232-1195 M-F 8-5 CST.
WARNING: If any parts are missing, do not attempt to plug in the power cord and turn “ON”
the Bench Grinder. The Bench Grinder can only be turned “ON” after all the parts have been
obtained and installed correctly.
The following items are to be provided in the shipping box:
1. Eye Shield Assembly (2)
2. Eye Shield Bracket (2)
3. Locking Knob M5 (2)
4. Tool Rest (2)
5. Lock Washer 6 (2)
6. Flat Washer 6 (2)
7. Carriage Head Screw M6x14 (2)
8. Tool Rest Knob M6 (2)
9. Hex Head Bolt M6x30 (2)
10. Spark Deflector (2)
11. Screw, Flat Washer and Spring Washer Kit (2)