Use and Care Manual

7
ASSEMBLY
In order to best protect the plate compactor while in the package, this product comes with some
components disassembled. Please complete the following assembly step before proceeding to use
the plate compactor.
If after reading this section, you are unsure about how to perform any of the steps, please call
[phone] M-F 8-5 CST for customer service.
WARNING: This plate compactor is heavy. Some procedures may require
lifting equipment or two people.
Handle Assembly
The Plate Compactor is shipped with the lower handle already assembled and attached to the plate.
To complete the handle assembly, loosen the knobs in the middle of the handle and swing the
upper handle into place.
Next, insert the bolt, washer and nut into the hole directly above the plastic knob as shown in the
illustration. Tighten the nut and the plastic knob.
Repeat the process on the other side of the handle.