Product Manual

USING YOUR GENERATOR

CONNECTING ELECTRICAL DEVICES

When the rated wattage requirement of each electrical device has been determined, add these numbers to ﬁnd the

total rated wattage needed. If this number exceeds the rated wattage (1900W) of the generator, DO NOT connect all

these devices. Select a combination of electrical devices with a total rated wattage lower than or equal to the rated

wattage of the generator.

CAUTION! Become familiar with the markings on the control panel (Fig. 14) before connecting electrical

devices. Do not connect 50Hz loads to the generator.

1. Before connecting electrical devices, allow the generator to run for a few minutes to stabilize the speed and volt-

age output.

2. Make sure that all devices are turned off. Start plugging in each electric device, from the highest wattage to the

lowest. Check the power indicator light (green) to ensure the generator is producing power.

3. Do not overload the generator or individual panel receptacles. If an overload occurs, the overload indication light

(red) will activate. If it is ﬂashing, turn off and unplug one load. If it is solid (not ﬂashing), the generator will cut

off power to protect itself. Unplug all electrical devices and then press the reset button to reset the entire circuit,

or press the circuit breaker to reset the DC circuit. Check the total wattage of the devices and reduce the load if it

exceeds the capacity of the generator. Then, plug the loads back in one by one.

NOTE: If the reset button or circuit breaker does not reset, wait several minutes and try again. If problem still per-

sists, please call 1-(800) 232-1195 M-F 8-5 CST.

NOTE: The NEMA 5-20 receptacles are capable of connecting devices up to 20A only when two generators are par-

allel connected. When operating a single generator, do not exceed 15.8A (1900 running watts) on this receptacle.

ECO-MODE

ON OFF

NEMA 5-20R

AC 120V

OUTPUT OVERLOAD OIL

RESET

DC 12V

2.1A

DC 5V USB

USB

PARALLEL CONNECT

CIRCUIT

BREAKER

CHOKE

START

RUN

POWER SWITCH

OFF FUEL

OFF

NEUTRAL FLOATING

Fig. 14