Use and Care Manual

WARNING: To avoid accidents, always disconnect the tool from the power supply before cleaning or

performing any maintenance.

CLEANING

1. Regularly clean the router with a soft cloth or compressed air. Remember to wear safety goggles when cleaning

tools with compressed air.

2. Regularly clean the router bits and collet carefully to remove dust and chips that have accumulated.

WARNING: Do not at any time let brake fluids, gasoline, petroleum based products, penetrating oils,

etc., come in contact with plastic parts. Chemicals can damage, weaken or destroy plastic which may result

in serious personal injury.

MAINTENANCE

CARBON BRUSHES INSPECTION AND REPLACEMENT

1. The wear on the carbon brushes depends on how frequently and

how heavily the router is used. For general use, it is recommended to

check the brushes every 6 months.

2. The carbon brush caps are located on the front and back of the

router. To access the brushes, unscrew and remove the two brush caps

with a flat head screwdriver (Fig. 24).

3. Take out and inspect the carbon brushes (Fig. 25). If the brushes are

worn to under 1/4” in length, replace them with new carbon brushes

and then reinstall the brush caps.

NOTE: Always keep carbon brushes clean and ensure that they slide

freely in the brush holders. Double carbon brushes should be replaced

at the same time.

PRODUCT DISPOSAL

When the product reaches the end of its lifetime, please do not dispose

of it with household waste. Electrical and electronic products are haz-

ardous to the environment and human health due to the presence of

hazardous substances. Take the product to your local recycling facility

for it to be responsibly recycled to minimize impacts on the environ-

ment.

Fig. 24

Fig. 25

Carbon Brush

Length