Use and Care Manual

OPERATION

WARNING - if any parts are missing, do not operate this tool until the missing parts are replaced.

Failure to do so could result in possible serious personal injury.

Recommended Hookup

Your air tool is fully assembly when you receive it. Before using it, attach the air line and desired air system acces-

sories. See below for the recommended accessories and connection order. Be sure the air hose is depressurized

when installing or removing adapters to the air line.

OPERATING AIR PRESSURE: 70-100 psi

Select the operating air pressure within this range for best tool performance.

DO NOT EXCEED THIS RECOMMENDED OPERATING PRESSURE.

LUBRICATION

This tool requires lubrication before each use (especially the first use). If an in-line oiler is used,

manual lubrication through the air inlet is not required.

Note: the work surface can become damaged by excessive lubrication. Proper lubrica-

tion is the owner’s responsibility. Failure to lubricate the tool properly will drastically

shorten the life of the tool and void the warranty.

1. Disconnect the air supply from the tool to add lubricant.

2. Turn the tool so the air inlet is facing up. Place 4-5 drops of 30W non-detergent oil

(included) into the air inlet.

3. After adding oil, run toll briefly. Wipe off any excess oil from the exhaust.