Use and Care Manual

OPERATION

LOADING THE STAPLE

Warning: TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION,

BEFORE LOADING:

• Wear ANSI-approved safety goggles with side shields. Other people in the work area must also wear

ANSI-approved impact safety goggles with side shields.

• Release the trigger.

• Detach the air supply.

• Attempt to fire the tool into a piece of scrap wood to ensure that it is incapable of firing any fasteners.

1. Only use the proper size and type of staple with this stapler.

2. Press the magazine lock to open up the magazine. Open the magazine completely by pulling the movable

magazine unit.

3. Turn the stapler upside down. Place a full clip of

staples inside the magazine so the pointed ends of the

staples are directed away from the stapler.

4. Keep fingers clear while sliding the movable

magazine unit closed until it clicks shut.

5. Rotate the exhaust deflector to redirect exhaust air

away from you.

GENERAL OPERATING INSTRUCTIONS

1. Always test the tool before each use.

2. If an automatic oiler is not used, add a few drops of Pneumatic Tool Oil to the airline connection before use.

Add a few drops more after each hour of continual use.

3. Place the head of the stapler against the surface you wish to staple. Be sure to keep your hands, fingers and

other body parts away from the nozzle.

4. Press the trigger to activate the stapler.

5. If the tool requires more force to accomplish the task, verify that the tool receives sufficient, unobstructed

airflow (CFM) and increase the pressure (PSI) output of the regulator up to the maximum air pressure rating of

this tool.

CAUTION! TO PREVENT TOOL AND ACCESSORY FAILURE, RESULTING IN INJURY:

Do not exceed the tool’s maximum air pressure rating of 100 PSI. If the tool still does not have

sufficient force at maximum pressure and sufficient airflow, then a larger tool may be required.

After use, to prevent accidents:

1. Release the trigger.

2. Detach the air supply.

3. Attempt to fire the tool into a piece of scrap wood to ensure that it is disconnected and is incapable of firing

any fasteners.

4. Release the trigger again.

5. Clean external surfaces with clean, dry cloth.

6. Store indoors and out of reach of children and unauthorized people.