Use and Care Manual

KNOW YOUR NAILER

Exhaust Cover

Trigger

Air Inlet

MagazineShingle Guide

Safety Bracket

Depth Setting Wheel

OPERATION

WARNING - if any parts are missing, do not operate this tool until the missing parts are replaced.

Failure to do so could result in a possibly serious personal injury.

RECOMMENDED HOOKUP (FIG. B)

Your air tool is fully assembly when you re-

ceive it. Before using it, attach the air line and

desired air system accessories. See the diagram

on the right for the recommended accessories

and connection order. Be sure the air hose

is depressurized when installing or removing

adapters to the air line.

Fig. A

Fig. B

LUBRICATION (FIG. A)

This tool requires lubrication before each use (especially the first use). If an inline

oiler is used, manual lubrication through the air inlet is not required.

NOTE: The work surface can become damaged by excessive lubrication. Proper

lubrication is the owner’s responsibility. Failure to lubricate the tool properly will

dramatically shorten the life of the tool and void the warranty.

1. Disconnect the air supply from the tool to add lubricant.

2. Turn the tool so the air inlet is facing up. Place 4-5 drops of 30W non-detergent

oil (included) into the air inlet.

3. After adding oil, run toll briefly. Wipe off any excess oil from the exhaust.