Use and Care Manual
7
KNOW YOUR SANDER
OPERATING INSTRUCTIONS
SANDPAPER INSTALLATION
WARNING: To avoid injury from accidental startups, turn switch OFF and remove the plug from
the power source outlet before making any adjustments.
1. Before installing sandpaper, make sure the hook and loop fastener base is free of dust and dirt and that the
sander is unplugged with the ON/OFF switch in the off position with the “O” pressed down.
2. The hook and loop fastener base will hold any hook and loop sandpaper without clamps or glue. Simply line
up the sandpaper with the hook and loop fastener base and press together, making sure front edge of the sandpa-
per is aligned with the front edge of the hook and loop fastener base.
3. There are also provided clamps to fasten non-hook-and-loop sandpaper to the sander. Insert end of new 1/4
sheet sandpaper approximately 1/2 in. under the paper clamp. NOTE: 1/2 in. clamping of sandpaper is necessary
for multi-sheet stacking of paper.
5. Lift up on paper clamp lever and lock into place. Apply downward pressure to conform sandpaper to sanding
base.
6. Wrap sandpaper around cushion. Lift lever on opposite end of sander and insert loose end of sandpaper un-
der the paper clamp. Fit sandpaper against cushion tightly.
7. Lift up on the lever and lock into place.
8. To remove used sandpaper, peel one edge away from the hook and loop fastener base until the whole sheet is
free.
CAUTION: Do not use torn or severely worn or damaged sandpaper. To do so could damage the surface of the
hook and loop fastener base.
ON/OFF Switch
Dust Collection Bag
Hook & Loop
Sanding Base
Paper Clamp
Release Lever