Use and Care Manual

7
KNOW YOUR SANDER
OPERATING INSTRUCTIONS
TOOL SET UP
WARNING: To avoid injury from accidental startups, turn switch OFF and remove the plug from the power
source outlet before making any adjustments.
INSTALLING NON-HOOK AND LOOP SANDPAPER
1. Unplug the sander.
2. Inspect the sandpaper before installing; do not use if broken or defective.
3. To remove paper, release paper clamp by lifting up on lever, and disengaging it from the tab on the sanding
base. Remove old sandpaper before replacing with new sandpaper.
4. Insert end of new 1/3 sheet sandpaper approximately 1/2 in. under the paper clamp. NOTE: 1/2 in. clamping
of sandpaper is necessary for multi-sheet stacking of paper.
5. Lift up on paper clamp lever and lock into place. Apply downward pressure to conform sandpaper to sanding
base.
6. Wrap sandpaper around cushion. Lift lever on opposite end of sander and insert loose end of sandpaper un-
der the paper clamp. Fit sandpaper against cushion tightly.
7. Lift up on the lever and lock into place.
CAUTION: Do not use torn or severely worn or damaged sandpaper. To do so could damage the
surface of the sanding base.
Switch
Dust collection bag
Sanding base