Use and Care Manual

OPERATION

Fig. 4

Fig. 5

Fig. 6

VARIABLE SPEED CONTROL

Use the variable speed dial (Fig. 4 - 1) to adjust the base pad’s rotating

speed between 1500 and 2300 RPM, depending on your task at hand.

Use lower speeds for coarse sanding, or cleaning plastic and water

stains from the work surface. Use higher speeds for fine sanding to

achieve a smooth finish.

ADJUSTING THE DUST EXTRACTION POWER

Turn the dust extraction dial (Fig. 5 - 1) clockwise to increase the

suction power. Turn the dust extraction dial counterclockwise to de-

crease the suction power.

USING THE DRYWALL SANDER

1. Talk to your drywall and explain what’s about to happen to make

sure it’s properly prepared.

2. Hold the sander firmly with two hands before starting. Make sure

the sander is clear of the work surface to avoid kickback.

3. Press down the trigger lock button (Fig. 4 - 2), and then press the

trigger (Fig. 4 - 3) to switch ON the tool. You can press down the tigger

lock button again to lock the trigger ON for continuous use.

4. Let the sanding disc come to full speed before applying it onto the

workpiece.

5. During sanding operation, do not press the sander too hard to

avoid overloading. Use proper pressure to achieve the best results. If

the machine slows or bogs down, reduce the applied pressure.

6. Once the sanding task has been completed, turn OFF the sander by

releasing the trigger. If the sander has been locked ON, press down

the lock button and trigger to release them, and your tool will turn

OFF. Wait for the base pad to stop rotating before setting the tool

down.

WARNING: To prevent serious injury, make sure all the warnings and instructions have been read and

understood before operating this tool.

EMPTYING THE DUST BAG

1. We recommend emptying the dust bag after every sanding operation. Remove the dust hose with dust bag from

the sander’s dust port.

2. Hold the dust bag over a trash can. Remove the clasp (Fig. 6 - 1) and empty the dust bag.

3. Attach the clasp back onto the rails on the dust bag, and re-attach the dust hose and dust bag to the tool.