Use and Care Manual
1. TOOL PURPOSE. This sander is designed to sand wood or wood-like products only. Sanding or grinding
other materials could result in fire, injury, or damage to the workpiece. Using the machine for any other pur-
pose for which it is not designed may result in serious injuries, machine damage and voiding of the warranty.
2. MACHINE MOUNTING. For operation safety, the sander must be securely mounted onto a flat and stable
surface or stand.
3. PERSONAL SAFETY.
• Always wear ANSI Z87.1-approved glasses with side shields, hearing protection and a dust mask.
• DO NOT wear loose clothing or jewelry, as they might get drawn in by the tool. Tie back long hair.
• DO NOT wear gloves while operating this machine.
4. ELECTRIC CORDS. Keep cords away from heat, oil, sharp edges, and moving parts of the tool. Have an
electrician replace or repair damaged or worn cords immediately.
5. TOOL & ACCESSORIES INSPECTION. Before operation, check the tool and accessories for any damage or
missing parts. Do not use the tool if any part is missing or damaged. Make sure all adjustments are correct
and all connections are tight. Keep all guards in place.
6. SANDING ACCESSORIES.
• Do not use sanding sleeves or drums that are damaged, torn, or loose. Replace worn or damaged sanding
sleeves before operation.
• Always unplug the unit before making adjustments or changing sandpaper, rubber drums or throat plates.
• Always use the throat plate that matches the diameter of the drum to minimize the gap between the drum
and the throat plate opening; this will reduce the risk of personal injury.
7. WORKPIECE REQUIREMENTS.
• Only stand workpieces sturdy enough to withstand the force of the sanding spindle.
• Inspect the workpiece for imperfections, nails, staples, etc. before sanding. Never sand stock that has
questionable imperfections or embedded foreign objects.
• When sanding a large workpiece, provide additional support. Do not sand with the workpiece unsupported.
• Sand only one workpiece at a time.
8. PREVENTING ACCIDENTAL STARTING. Make sure the power switch is in the OFF position prior to plug-
ging in the machine. Always make sure the power switch is in the OFF position and the machine is un-
plugged when doing any cleaning, assembly, setup operations, or when not in use.
9. Do not operate this tool until it is completely assembled and installed according to the instructions.
10. Remove scrap pieces and other objects from the table and sanding sleeve before turning ON the sander.
SPECIFIC RULES FOR THE SPINDLE SANDER
WARNING: Do not let comfort or familiarity with the product replace strict adherence to product
safety rules. Failure to follow the safety instructions may result in serious personal injury.
6