Use and Care Manual

ASSEMBLY

1. Attach the 2 wheel brackets to the 2 wheel-

mounting legs with (4) M8-1.25 x 16 hex bolts

and (4) M8-1.25 lock nuts. Note that the left and

right wheel brackets are different configurations.

Tighten the fasteners with a wrench.

2. Slide the wheel axle through the 2 wheel

brackets. Then install the two wheels onto the

two ends of the wheel axle.

3. Secure the 2 wheels with the 2 cotter pins by

inserting them through the axle holes and bend-

ing back the ends.

STEP 2: INSTALLING THE WHEELS (Fig. 2)

STEP 3: INSTALLING THE HANDLES (Fig. 3)

1. Attach the lifting handle assemblies onto the handle-mount-

ing with (4) M6-1 x 10 flat head screws and (4) M6-1 lock

nuts.

2. Use a Phillips screwdriver to hold the mounting screws

stationary while tightening the locking nuts with a suitable

wrench.

NOTE: The handle should be able to swing up 90 degrees

from the “down” position, but not any farther

Wheel Brackets (x2)

Lifting Handle

Assemblies (x2)

Wheel Axle (x1)Wheels (x2)

M8-1.25 x 16

Hex Bolts (x4)

M8-1.25

Lock Nuts (x4)

M6-1 x 10

Flat Head Screws (x4)

M6-1

Lock Nuts (x4)

Cotter Pins

4 x 20mm (x2)

Fig. 2

Fig. 3