Use and Care Manual

STEP 4: MOUNTING THE MACHINE ONTO THE STAND (Fig. 4)

STEP 5: INSTALLING THE HEIGHT ADJUSTMENT WHEEL (Fig. 5)

ASSEMBLY

1. This sander weighs over 150 lbs, so you will need a strong mus-

cular friend (or a trustworthy foe) to help you lift it up. Carefully

place the sander onto the assembled stand in the orientation you

prefer (the motor side of the sander can be positioned above the

wheels side or the handles side).

2. Align the mounting holes on the base of the machine with the

holes on the stand. Mount the machine in place using (4) M10-1.5

x 30 hex bolts, (4) 10mm flat washers, and (4) M10-1.5 hex nuts.

Tighten the fasteners using a wrench.

NOTE: If necessary to align the mounting holes, you can slightly

loosen the stand fasteners. Be sure to re-tighten them after secur-

ing the sander assembly.

Drum Sander Assembly (x1)

Height Adjustment Wheel

Assembly (x1)

M10-1.5 x 30

Hex Bolts (x4)

10mm Flat Washers (x4)

M12-1.75 Acorn Nut (x1)

M10-1.5 x 30 Hex Nut (x4)

12mm Large Washer (x1)

Fig. 4

Fig. 5

Attach the height adjustment wheel onto the screw on top of the

sander. Mount the 12mm large washer and M12-1.75 acorn nut

on top of the wheel and tighten the nut.