Product Manual

GET TO KNOW YOUR SERVICE CART
See the "Get to Know Your Service Cart" section on page 2.
1. Remove all parts and hex tool from the box.
2. Place the bottom shelf upside down on the floor. Insert a holder into each of the four openings located on the
corners of the shelf. Use a rubber hammer (not included) to secure them into place; there should be no space where
the holders and base meet.
3. Push a nut into the hex tool and set aside. Propping the shelf on its side, insert a caster through the hole in the
holder and the base assembly. Place a washer onto the thread of the caster shank. Take the loaded hex tool and turn
right to secure the nut onto the thread of the caster shank. Repeat with all four casters, making sure that the two
non-locking casters and the two locking casters are on the same short sides as each other. See Fig. 2.
NOTE: To fully tighten the nuts, use a 17mm socket and a socket wrench or impact driver.
4. Set the assembled base down with wheels touching the floor. Push four of the legs into the openings located on
the corners of the base. Tap them into place with a rubber hammer.
5. Take the middle shelf and align the legs with the openings in the corners of the shelf. Tap the four corners of the
middle shelf with a rubber hammer to fasten the middle shelf to the legs.
6. Push the remaining four legs into the openings located on the corners of the middle shelf. Tap them into place
with a rubber hammer.
7. Take the top shelf and align the legs with the openings in the corners of the shelf. Tap the four corners of the top
shelf with a rubber hammer to fasten the top shelf to the legs.
8. Push the four covers into the openings on the corners of the top shelf. Tap into place with a rubber hammer.
9. Make sure all connections are flush and hardware is tightly fastened. Roll the cart to make sure that the cast
-
ers roll properly. Your service cart is now ready for use. Do not exceed the total load capacity of 300 lbs, evenly
distributed.
OPERATION
Before operation, you must assemble your Service Cart following the instructions above.
1. On a level surface, with the rear casters locked, begin placing objects onto your service cart. Remember to dis
-
tribute items evenly; uneven weight distribution could cause the cart to tip.
2. Unlock the rear casters and begin rolling the cart.
3. When stopped, lock the rear casters and unload the cart.
NOTE: Make sure the locking casters are in the OFF/unlocked position before attempting to push the Service Cart,
otherwise you can risk damaging the casters.
INSTRUCTION MANUAL INSTRUCTION MANUAL
ASSEMBLY
Shelf
Cover
Leg
Holder
Casters
Locking Casters
Fig. 1
NutWasher
Opening
Holder
Non-Locking CastersLocking Casters
Fig. 2