Replacement Instructions

Fig. 2.
4. Using the screwdriver, unscrew the six (6) screws holding the silver base plate in place. Refer to the
red circles in Fig. 2 above. Remove the plate.
5. Using the screwdriver, unscrew the six (6) screws holding the table and motor assembly to the body
of the sander. Refer to Fig. 3 below. NOTE: You will also have to disconnect the 2 brown wires (see
Fig. 3 below) from the motor connector plate. Take a picture so you can remember the proper
connection points for these wires later, when reassembling the sander.
Fig. 3.