Product Manual

ASSEMBLY & ADJUSTMENTS

INSTALLATION ON TABLES WITH THROUGH SLOTS

1. Slide the heads of the M8x90 bolts (Fig. 1 - 1) into the back

T-track (Fig. 1 - 2), one on each side, and slide one into the front

T-track (Fig. 1 - 3), if desired.

2. Position the bolts in the back T-track such that they ﬁt through

the the slots on the metal drill press table. Place them through

the slots (Fig. 2). Position the table so that the front bolt is lined

up with the front of the table, or passes through a slot or hole in

the metal table, depending on your drill press model.

3. Attach the clamp assemblies to the bolts in the following or-

der: Clamp, clamp bushing, washer, knob (Fig. 3).

4. Tighten the knobs on the clamp assemblies. Make sure that

the drill press table is properly aligned and centered before the

knobs are fully tightened.

NOTE: For the most secure clamping, have the clamps resting

against a ﬂat surface underneath the table. If the front clamp

assembly is not placed through a slotted hole, have the rounded

end of the clamp (Fig. 4 - 1) gripping the front lip of the metal

drill press table (Fig. 4 - 2).

NOTE: To ensure the clamps are locked into place properly, check

that the clamp bushings are properly seated into the clamps.

The rounded tops of the bushings (Fig. 5 - 1) should mate with

one of the rounded grooves in the clamps (Fig. 5 - 2). Once the

clamps are properly seated, fully tighten the knobs.

Fig. 1

Fig. 2

Knob

Washer

Bushing

Clamp

Fig. 4

Fig. 3

Fig. 5

2 2