Product Manual

ASSEMBLING THE STOP BLOCK

1. Place the M6x40 bolt (Fig. 7 - 1) though the stop block (Fig.

7 - 2) and washer (Fig. 7 - 3). Loosely thread the stop block knob

(Fig. 7 - 4) onto the bolt.

2. Slide the bolt through the T track on the fence (Fig. 8 - 1) such

that the bottom of the stop block (Fig. 8 - 2) lies against the top

of the table (Fig. 8 - 3).

3. Slide the stop block to the desired position and lock it in place

by fully tightening the knob.

ASSEMBLING THE HOLD DOWN CLAMPS

Your drill press table comes with two hold down clamps, which

can be used to clamp down a workpiece to the drill press table.

1. Assemble the hold down clamps in the same order as the

clamp assemblies under the table, as seen in Fig. 2.

2. Slide the bolts of the hold down clamps (Fig. 9 - 1) into the

top T-slots on top of the table (Fig. 9 - 2).

3. Place the workpiece on the drill press table and clamp it down

by tightening the knobs. Make sure the clamp bushings are

seated properly in the clamps.

ASSEMBLY & ADJUSTMENTS

Fig. 7

Fig. 8

Fig. 9

2 2