SDS

Hangzhou Wanma High-energy Battery Co., Ltd
Add:No.118, Linban Road,GongShu Hangzhou, China Postalcode:310022
TEL: [phone] 88368926 FAX: [phone]
Case Material
CONTENT
（percent of total weight）
CAS No.
EINECS
ABS
100%
9003-56-9
4. FIRST-AID MEASURES
Caution! No effect under routine handling and use. If exposure to internal materials within cell due to
damaged outer metal casing, the following actions are recommended.
Inhalation: If inhaled, remove from exposure and move to fresh air immediately. Rinse mouth and
nose with water. Get medical aid immediately. Do NOT use mouth-to-mouth resuscitation. If
breathing as ceased apply artificial respiration using oxygen and a suitable mechanical device such as
a bag and a mask.
Skin: In case of contact, immediately flush skin with copious amounts of water for at least 15-30
minutes while removing contaminated clothing and shoes. Wash clothing and shoes before reuse. seek
medical aid immediately.
Eyes: Rinse immediately with plenty of water during at least 15-30 minutes, occasionally lifting the
upper and lower eyelids. Check for and remove any contact lenses if easily possible. Get medical aid
immediately.
Ingestion: Do not induce vomiting. If the injured is fully conscious: wash mouth out with water, then
give 2-4 cupfuls of milk or water. Never give anything by mouth to an unconscious person. Seek
medical aid immediately.
Most important acute and delayed symptoms/effects: See Part 11 for more information.
Protection of first-aiders: Use proper personal protective equipment as indicated in Part 8.
Note To Physicians: Treat symptomatically and supportively.
5. FIRE-FIGHTING MEASURES
Extinguishing Media: Class D-Dry chemical powder, sand is suitable. Do NOT use water.
Hazard properties
：
the battery may be over-heated by outside and interior short-circuit, and burning
batteries may emit toxic fumes.
Hazardous Combustion products: metallic oxide, Carbon oxide (CO), Carbon dioxide (CO
2
), etc.
Firemen safeguard: firemen should wear fire-fighting suits with a self-contained breathing apparatus
Specific Extinguishing Methods: Promptly isolate the scene by removing all persons from the
vicinity of the incident if there is a fire. No action shall be taken involving any personal risk or
without suitable training. Approach fire from upwind to avoid hazardous vapors and toxic
decomposition products. Move containers from fire area if this can be done without risk. Prevent run
off from fire control dilution from entering streams or drinking water supply.
6. ACCIDENTAL RELEASE MEASURE
General information
：
employ proper protection establishment according to directions of part.8.
Person-related Safety Precautions: No action shall be taken involving any personal risk or without
suitable training. Review part 5 and part 7 sections before proceeding with clean-up. Use proper
personal protective equipment as indicated in Section 8. Appropriate ventilation. If electrolyte
leaks or spills, do not touch or walk through electrolyte.
Measures for Environmental Protection: In the event of battery rupture, prevent skin contact and
collect all released material in a plastic lined container. Dispose off according to the local law
and rules. Avoid leached substances to get into the earth, canalization or waters.
Measures for Cleaning/Collecting: If battery casing is dismantled, small amounts of electrolyte may
leak. Pack the battery including ingredients as described above. Then clean with water (diluted
2