Product Manual

INSTRUCTION MANUAL

KNOW YOUR PEN PRESS

MODEL LA3040

PEN PRESS

THANKS FOR

REMEMBERING

V. 2019.09.16

ASSEMBLING YOUR PEN PRESS

1. Affix the handle to the toggle clamp and secure with

the included screw. (Fig. 1)

2. The pen press comes with mounting holes. This

enables the pen press to be mounted onto a work

surface for secure pressing. To do so, insert six M6

flathead screws (not included) into the mounting

holes. (Fig. 2)

Fig. 1

Fig. 2

1. Adjustment Knob

2. Tip-End Rod

3. Press Cylinder

4. Base

5. Rubber Grip

6. Handle

7. Toggle Clamp

6. Flathead Screw

INCLUDED

FLATHEAD SCREW

NOTE: The pen press does not need to be mounted and can be used simply by holding the base with

one hand.

PAGE 1
INSTRUCTION MANUAL MODEL LA3040 PEN PRESS KNOW YOUR PEN PRESS 5 8 Fig. 1 INCLUDED FLATHEAD SCREW 6 1 THANKS FOR REMEMBERING 2 3 7 4 1. Adjustment Knob 2. Tip-End Rod 3. Press Cylinder 4. Base 5. Rubber Grip 6. Handle 7. Toggle Clamp 6. Flathead Screw Fig. 2 ASSEMBLING YOUR PEN PRESS 1. Affix the handle to the toggle clamp and secure with the included screw. (Fig. 1) 2. The pen press comes with mounting holes. This enables the pen press to be mounted onto a work surface for secure pressing.
PAGE 2
INSTRUCTION MANUAL WARRANTY OPERATION 1. Move the handle (Fig. 3 - 1) to the back, unpressed position. Fig. 3 2 2. Loosen the adjustment knob (Fig. 3 - 2) so that the tip-end rod can be repositioned 3. Reposition the tip-end rod (Fig. 4 - 1) such that the tip (Fig. 4 - 2) is located within the tip locator cylinder and the back of the pen is against the press cylinder (Fig. 4 - 3).