Product Manual

ASSEMBLE THE FIXED WHEELS (FIG. 1 & 2)

Parts Needed:

• Back Corner Brackets (2)

• Wheels (2)

• M6x50 Hex Bolts (2)

• Wheel Spacers (2)

• M6 Lock Nuts (2)

• 10mm Wrench (1)

1. From the outside of the corner bracket (Fig. 1 - 1), insert a M6x50 hex bolt

through the wheel bracket, the wheel and the wheel spacer (Fig. 2 - 1). At-

tach the M6 lock nut from the inside of the bracket and tighten with a 10mm

wrench.

NOTE: Do not overtighten the nut, as this could pull the screw head against

the mounting bracket and cause the bracket to deform, impeding the wheel’s

function.

2. Repeat for the other back corner bracket.

ASSEMBLE THE SUPPORT FEET (FIG. 3 & 4)

Parts Needed:

• Front Corner Brackets (2)

• Support Feet (2)

• M10 Nuts (2)

• 17mm Wrench (1)

1. Take a front corner bracket (Fig. 3 - 1) and screw in the support foot (Fig.

3 - 2) from the bottom of the foot ﬂange.

NOTE: Adjust the height of the rubber foot so that the foot’s bottom surface

is at the same height as the bottom of the ﬁxed wheels. This will make the

base level when resting on the rubber feet and wheels.

2. Attach the M10 nut onto the rubber support foot. Check that the foot is

set at a suitable height and tighten the M10 nut against the ﬂange using a

17mm wrench.

3. Repeat for the other front corner bracket.

ASSEMBLY & ADJUSTMENTS

TOOLS NEEDED (NOT INCLUDED):

• Tape Measure • 13mm (1/2 in.) Wrench or Socket

• 10mm (3/8 in.) Wrench or Socket • 17mm (5/8 in.) Wrench or Socket

WARNING! Do not operate the mobile base until it has been fully assembled according to the instructions.

Follow all warnings to reduce the risk of personal injury or machine damage.

Fig. 1

Fig. 2

Fig. 3

Fig. 4