Product Manual

ASSEMBLE THE SWIVEL PLATES (FIG. 5)

Parts Needed:

• Swivel Plates (2)

• M6x70 Hex Bolts (2)

• M6 Lock Nuts (2)

• 10 mm Wrench (1)

1. From the outside of the front corner bracket, insert the M6x70 hex bolt

through the lower hole of the caster ﬂange (Fig. 5 - 1) and the swivel plate

(Fig. 5 - 2). Secure with an M6 lock nut from the other side of the caster

ﬂange and tighten it using a 10mm wrench.

2. Check that the swivel plate is able to swivel upwards, but not downwards.

ASSEMBLE THE SWIVEL CASTERS (FIG. 6)

Parts Needed:

• Two swivel casters (8)

• Two caster lock washers (S6)

• Two M10 nuts (S4)

• 17mm wrench

1. From the bottom of the swivel plate, insert the swivel caster (Fig. 6 - 1)

through the swivel plate (Fig. 6 - 2) and the caster lock washer. Secure with

an M10 ﬂange nut and tighten the nut using a 17mm wrench.

ASSEMBLE THE FOOT LEVERS (FIG. 7, 8, & 9)

Parts Needed:

• Foot Levers (2)

• M8x70 Hex Bolts (2)

• Lever Spacers (4)

• Lever Lock Washers (2)

• M8 Nuts (2)

• 13mm Wrench (1)

1. From the outside of the front corner bracket, insert the M8x70 hex bolt

through the upper hole of the caster ﬂange (Fig. 7 - 1), a lever spacer, the

foot lever (Fig. 8 - 1), another lever spacer, and ﬁnally through the upper

hole on the inside of the caster ﬂange. Attach the lever lock washer and M10

ﬂanged nut from the inside of the caster ﬂange and tighten the nut using a

13mm wrench.

2. Test the mechanism of the foot levers. When the foot lever is depressed,

the base will be mobile, resting on the caster wheel. When the foot lever is

raised, the caster wheel will be raised with the rubber foot resting on the

ground and the base will be static (Fig. 9).

ASSEMBLY & ADJUSTMENTS

Fig. 5

Fig. 6

Fig. 7

Fig. 8

Fig. 9