Product Manual

ASSEMBLING THE PRESSURE WASHER

1. Slide the gun holder (Fig. 1 - 1) onto the rail on the side

of the pressure washer.

2. Slide the detergent tank bracket onto the rail on the side

of the pressure washer. Install the onboard detergent tank

(Fig. 1 - 2) in the bracket.

ATTACHING THE TRANSFER HOSE

1. One end of the transfer hose (Fig. 2 - 1) will come

pre-assembled under the hose reel. The other end of the

transfer hose will need to be connected to the pump outlet

(Fig. 2 - 2).

ASSEMBLING THE HIGH PRESSURE HOSE

1. Connect the high pressure hose coupler (Fig 3 - 1) to

the connector located on the bottom of the spray gun

(Fig. 3 - 2). Tighten with an adjustable wrench (not

included) to secure hose connection.

ASSEMBLING THE SPRAY GUN

1. Insert the spray lance (Fig. 4 - 1) into the spray gun

(Fig. 4 - 2) and twist to lock them in position.

CONNECTING THE GARDEN HOSE

1. Run water through the hose for a few seconds to flush

any debris from the hose. Turn off the hose.

2. Inspect water inlet screen (Fig. 5 - 1) and remove any

debris.

3. Connect hose (Fig. 5 - 2) to water inlet (Fig. 5 - 1) and

tighten by hand. There must be a minimum of 10 feet of

unrestricted hose between pressure washer and faucet or

shut-off valve.

4. Turn water supply on.

CAUTION:

Only use clean water for the pressure washer.

Use of unfiltered water containing corrosive chemicals

will damage the unit.

ASSEMBLY

WARNING:

The intake water temperature must

not exceed 104°F (40°C). The water supply must not

exceed 101 PSI (700 kPa).

Fig. 1

Fig. 2

Fig. 3

Fig. 4

Fig. 5

1 2