Product Manual

USING THE SPRAY GUN

Flip the lock tab (Fig. 6 - 1) behind the trigger up or down

until it clicks to apply or remove the safety. Pull back on

the trigger (Fig. 6 - 2) to begin operating pressure washer.

To stop water flow, release trigger.

USING THE ADJUSTABLE NOZZLE (FIG. 7)

The spray gun features an adjustable nozzle that lets you

adjust the spray pattern from a full fan spray (widest spray

width) to a direct stream spray (narrowest spray width).

OPERATION

WARNING:

Make sure the spray tip is pointed away

from any people or animals when adjusting the nozzle.

NOTE: Always begin by spraying a testing area of the work

surface using the fan spray (widest spray width) to avoid

damaging the surface.

Rotate the adjustable nozzle counterclockwise to increase

the spray width. Rotate the adjustable nozzle clockwise

to decrease the spray width. Refer to Fig. 7.

PREPARING THE PRESSURE WASHER

1. Place the pressure washer on a secure, stable surface to prevent it from tipping during operation.

2. Check that all connections have been properly installed and secured.

• The high pressure hose is properly fastened to the gun hose connector.

• The spray lance is properly attached to the spray gun .

• The garden hose is properly fastened to the pressure washer’s water inlet adapter.

CAUTION: This unit is intended to be used with cold water only. Do not use hot water in this pressure

washer.

3. Turn on the water supply on.

4. Release the trigger safety lock and pull the trigger for a few seconds until water flow is steady. This

will allow air to escape and discharge any pre-existing pressure from the gun and the hose. Then turn

off the water.

Fig. 6

Fig. 7