Product Manual

13
OPERATING THE PRESSURE WASHER
1. Make sure the ON / OFF switch is in the OFF position.
Plug the Ground Fault Circuit Interrupter (GFCI) into a
matching receptacle (see page 8 for important electrical
information). We recommend that you test the GFCI as
part of your startup procedure each time you use your
pressure washer as instructed below.
Press the RESET button (Fig. 8 - 1), and the power
indication light should turn on. Press the TEST button
(Fig. 8 - 2), and the power indication light should turn off.
Do not use if the test fails. Press the RESET button again
after completing the test to enable operation.
2. Point the gun at a safe direction, aimed away from any
bystanders or animals. Set the ON / OFF switch to ON
(Fig. 9).
3. Hold the gun firmly and pull the trigger to begin pressure
washing. Beware of kickback when pressing the trigger.
OPERATION
WARNING: Never direct the water steam at people,
animals or electrical devices. The high-pressure spray
can cause severe injury.
AUTOMATIC PUMP SHUTOFF / TSS (TOTAL STOP SYSTEM)
The pressure washer is equipped with an automatic pump shutoff function that senses the water flow
in the pump. The pump will only run when the power switch is in the ON position and the trigger pulled.
When the trigger is released and no water is flowing through the pump, the motor will automatically
shut off to protect the pump from overheating, thus saving energy and prolonging pump life.
THERMAL SENSOR
The pressure washer is equipped with a thermal sensor that protects the motor from overloading.
When overloaded, machine will shut down and restart after a few minutes once the motor has cooled.
USING PRESSURE WASHER DETERGENT
1. The onboard detergent tank is located on the side of the pressure washer. Open the rubber cap and
fill the reservoir with your preferred pressure washer detergent.
CAUTION: Use only detergents designed for pressure washers. Follow the instructions included with
your detergent about how it should be prepared and used.
2. To drain detergent from the unit, take out the detergent tank and dump the contents out. Afterwards,
spray the gun to flush out all of the soap remaining in the unit.
1
2
WARNING: O nly use the fan setting with pressure washer detergent.
Fig. 8
Fig. 9