Users Manual

7
/
8
2.9 Information on test modes and additional testing requirements
Host manufacturer must perfom test of radiated & conducted emission and
spurious emission, etc. According to the actual test modes for a stand-alone
modular transmitter in a host, as well as for multiple simultaneously transmitting
modules or other transmitters in a host product. Only when all the test results of
test modes comply with FCC requirements, then the product can be sold legally.
2.10 Additional testing, Part 15 Subpart B disclaimer
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Caution:
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate this equipment. This
transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.
Radiation Exposure Warning:
- The equipment complies with FCC RF exposure limits set forth for an
uncontrolled environment.
- The equipment must not be co-located or operating in conjunction with any