User's Manual

the receiver host alarm icon " " and the tire pressure indicator " " flashes together with the tire
data value, and gives out "Di..Di" two buzzer sound. If the tire pressure value lower than "1.80Bar" of
setting. and and tire data value are flashing together and give out continuous “Di..Di..Di…”
buzzer sound. (As shown below)
(Low pressure alarm and rapid tire leak alarm)
High temperature alarm
When Receiver host detects that a tire temperature exceeds the setting value, the receiver host alarm
icon " " and the tire pressure indicator " " flashes together with the tire data value, and gives out
continuous “Di..Di..Di…” buzzer sound. (As shown below)
(High temperature alarm)
No signal alarm
During the course of driving, when the receiver host does not receive the signal transmitted from the
sensor for 10 minutes, its alarm icon will be flashing continuously. but the tire pressure indicator
" " is not flashing. No data shows on tire pressure and temperature area. But only icon “ / ”
light on. gives out continuous “Di..Di..Di…” buzzer sound. (As shown below)
(No signal alarm)
Tire exchange setting
If you want to exchange the tires, it needn’t re-install the sensor, just need to adjust data in receiver host.
Turn on receiver host and hold on M key to enter pressure setting interface. 12 times to click M key to
enter adjust data. (As shown below). is stand for front-left tire, is stand for front-right tire,
is stand for back-left tire. is stand for back-right tire. If you want to change front-left tire to
back-right tire, please choose and click forward key or back key to and hold on forward