User's Manual

2. Sensor installed
A. Put your car on the lift platform and set the car lifted to the appropriate height. Use wind gun spin
each tire to remove the screws, and remove the tire and do some remark. (As shown below)
B. Remove the tire from the valve core and let the tire be placed on the workbench of the tire removal
machine and peel the tire off the wheel. (As shown below)
C. Remove the original valve from the removed hub and clean the valve and remove the sensor. Specify
the position according to the sensor label (for example, the left front wheel can only correspond to the
left front wheel sensor, left front tire Is not installed right front wheel sensor), and the sensor installed in
the original to remove the valve position, and then use a special sleeve to tighten the sensor, and fixed
screws. (As shown below)
D. Coated the edge of tire with lubricant and then put the tire back to the wheel hub which fixed a
sensor already. According to your tire standard pressure spec to pump up the tyres. Then put the tire on
the balance machine table to do wheel alignment. (As shown below)
E. Remove the tires from the balance machine table and reload the tires into the car. Pick out the
warning lable and stick to the position where the sensor is installed on the wheel hub (Tips: carefully
removing the tire and the sensor inside). (As shown below)