User's Manual

F. Please repeat the above steps, to make sure all set sensor already installed.
Receiver host turn on / off key function introduction
1. Turn on/off switch
A. In the condition of power off, you can choose back key, M key(Menu key), forward key of the receiver
host to turn on the TMPS.
B. In the condition of power on, you can only choose back key, hold on it to turn off the TMPS.
2. M Key
In the condition of receiver host working mode, hold on M key to “Menu and Settings", in which you
choose "select and confirm" button.
3. Forward key
In the condition of receiver host working mode, hold on forward key for 3 seconds to clear all data from
the main interface. Since then the display will shows , “Add” key will apears in the settings menu.
4. Back key
In the condition of receiver host working mode, hold on back key for 5 seconds to turn off the TPMS,
“Reduce” key will apears in the settings menu
Receiver host and sensor pairing
Pairing way A: Pick out and turn on the TPMS, hold on "M" key to enter the air pressure setting interface,
then click the "M" key for 7 times to enter the tire matching settings interface, (as shown below) and
click the forward key or back key untill the display shows icon / . Twist down the cap of the
valve, which fixed the sensor already.Make sure tire pressure remains between 0.7-1.5Bar, by tire
inflation or deflation, they can pair themselves. Once hearing the receiver host gives out "Di..Di..Di .."
buzzer sound, the sensor has been paired success, at the same time the barometric data values and
temperature data values will show on the screen.
Pairing way B: when way A is not working please try the way B. Move out to your can/vain to outside for
real run pairing. Pick out and turn on the TPMS, hold on "M" key to enter the air pressure setting
interface, then click the "M" key for 7 times to enter the tire matching settings interface, (as shown
below) and click the forward key or back key untill the display shows icon / . Make your
Your Attention
By manual shutdown, TMPS will not reboost automatically during your driving. You can only
choose back key, M key or forward key to re-start the TMPS.
Reminder
Testing is necessary after the installation of sensor to ensure TPMS can be used. For example when a
car running for certain journey that can be checked the receiver host to see whether data is good to
receive. Any questions, please contact customer service for technical support.