User's Manual

will show kinds of update data of pressure.
K. This icon “ ” is stand for tire temperature. When sensor working in normal transmitte mode. This
icon will show kinds of update data of temperature.
2. Receiver host function settings introduction
Pick out receiver host and turn it on. TPMS pressure and temperature interface is synchronized display.
The temperature shows on both lowe left and lowe right corner, there 4 middle icons are pressure
display. (As shown below)
Turning on the TPMS and hold on M key to enter pressure unit setting interface. (As shown below). Click
forward key or back key there will be two icons / for your choose. Select the one you need
then click M key to save.(At the same time save next item setting) or wait for 15 seconds, it can be save
automaticallyand back to main interface.
When TPMS is working, hold on M key to enter pressure setting interface. Click M key one more time
enter temperature unit setting interface. (As shown below) When enter this interface please click
forward key or back key there will be two / units for your choose. Select the one you need, click
M key again to save. (At the same time save next item setting) or wait for 15 seconds, it can be save
automaticallyand back to main interface.
When TPMS is working, hold on M key to enter pressure setting interface. Twice click M key enter low
pressure alarm setting interface. (As shown below). Click on forward key or back key to set the tire
pressure to 1.8 Bar. Normally tire normal pressure "2.0-2.8Bar" low pressure can not be lower than "1.8
Bar".
(Tire low air pressure setting)
When TPMS is working, hold on M key to enter pressure setting interface. Three times click M key enter
tire high air presssure alarm setting interface. (As shown below). Click forward key or back key to set the
tire air pressure to 3.0 Bar. Normally tire normal pressure "2.0-2.8Bar" High air pressure can not be
higher than "3.0 Bar".
(Tire high pressure setting)