Use and Care Manual

7
4 SPRING LOADED “J” LOCKS
LOCK OPERATION
For safety, follow these Spring Loaded “J” Locks instructions:
The ladder's outer sections allow the ladder to
telescope and change heights in all the
congurations. Each of these congurations is
made possible using the 2 Spring Loaded “J”
locks, on the front section of the ladder.
The Spring Loaded “J” locks are operated by
pulling straight out and then rotating them away
from the holes in the rails. Each “J” lock works
independently allowing the end user to work the
lock with one hand while holding the ladder with
the other.
To adjust the height of the ladder:
1) Unlock the 2 “J” locks by pulling out and
rotating the “J” lock away from the rung
hole (See Figure 3).
2) Raise the inner section to the desired height.
3) While holding the inner ladder section with
one hand, lock the 2 “J” locks by rotating
them into the locked position
(See Figure 4).
4) Ensure both “J” locks are secure in a rung
hole before climbing.
UNLOCKED LOCKED
UNLOCKED LOCKED
Figure 4
•
Maintain control of the inner section while raising or lowering,
failure to do so could result in injury.
CAUTION
LOCKED
Figure 3
UNLOCKED