Use and Care Manual

5 PROPER USE

HOW TO SET UP POSITIONS

The Telescoping Multiladder can be used in positions shown below with no additional

equipment required. The following instruction will demonstrate how to change the

Telescoping Multiladder.

Position #1

Twin Stepladder

1) To congure the ladder into the stepladder

position, follow the directions for changing the

angle of the ladder (Section 3) using the

hinge lever.

Note: The stepladder position is easiest

completed with the ladder standing up. In this

position excess pressure is not exerted on

the hinge.

2) At this point the height of the ladder can be

changed to the desired height using the Spring

Loaded “J” locks for the front section and the

instructions for them (Section 4).

• For every position all hinges are supporting hinges and must be locked.

• Never straddle front and rear sections.

• Always face ladder and maintain rm grip while on it.

• DO NOT stand on or above second rung from top of ladder.

CAUTION