Use and Care Manual
10
1) Conguring the ladder into the extension ladder position,
as with the stepladder position, the extension ladder
position starts with changing the angle.
Note: The hinge levers will catch in each of the 3 positions.
Continue to hold the levers and rotate the sections until the
fully open extension ladder position is reached.
2) Unlock both sets of “J” locks and extend outer section
to desired length. Make sure “J” locks are
properly engaged.
3) With all locks properly engaged, lift ladder from one end
and slowly walk ladder up until it rests against desired
surface. Watch for overhead wires.
4) Adjust ladder to proper climbing position or
approximately 72°.
75°
Approximately
• Hinges and “J” locks must be secure before climbing.
• Never use ladder jacks on this ladder.
• DO NOT stand on or above second rung from top of ladder.
• Refer to set up caution label on ladder for proper set up.
CAUTION
6 PROPER USE
HOW TO SET UP POSITIONS (continued)
Position #3
Extension Ladder