User Manual

ManualsBrandsWerner ManualsBuilding materialsUpgear 3 ft. DeCoil Lanyard (DCELL Shock Pack, 1 in. Web, Snap Hook)

WARNING!

Compliant fall protection equipment must only be used as it was designed. Users MUST read and follow

all user instructions provided with the product. Before using a fall arrest system, users must be trained in

the safe use of the system, as required by OSHA 29 CFR 1910.30 and 1926.503, or local safety regulations.

Misuse or failure to heed these warnings and instructions may result in injury or even death.

WORK SAFE! WORK SMART!

PERSONAL ENERGY ABSORBERS AND

ENERGY ABSORBING LANYARDS

Complies with the ANSI Z359.13 standard and OSHA 29 CFR 1910 and 1926 regulations.

USER INSTRUCTIONS

IF YOU HAVE ANY QUESTIONS ABOUT THE PROPER USE OF THE EQUIPMENT, SEE YOUR SUPERVISOR, USER

INSTRUCTIONS, OR CONTACT WERNER CO. FOR MORE INFORMATION.

(This manual applies to all lanyards with model numbers starting C3, C4, C5, C6, C8 and C9 )

DeCoil

ENERGY ABSORBING LANYARD

DeCoil

ENERGY ABSORBING ELASTIC LANYARD

Summary of content (8 pages)

PAGE 1
USER INSTRUCTIONS PERSONAL ENERGY ABSORBERS AND ENERGY ABSORBING LANYARDS Complies with the ANSI Z359.13 standard and OSHA 29 CFR 1910 and 1926 regulations. DeCoil TM ENERGY ABSORBING LANYARD DeCoil TM ENERGY ABSORBING ELASTIC LANYARD (This manual applies to all lanyards with model numbers starting C3, C4, C5, C6, C8 and C9 ) WARNING! Compliant fall protection equipment must only be used as it was designed. Users MUST read and follow all user instructions provided with the product.
PAGE 2
GENERAL SAFETY INFORMATION These User Instructions are not to be removed except by the user of this equipment. Current User Instructions must always be available to the user. WARNING! 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. 15. 16. Failure to follow all instructions and limitations on the use of the Werner Co. Roofing Safety System may result in serious personal injury or death. Minors, pregnant women and anyone with a history of either back or neck problems should not use this equipment.
PAGE 3
1. 2. 3. 4. The complete fall arrest system must be planned (including all components, calculating fall clearance, and swing fall) before using. Users must have a rescue plan, and the means at hand to implement it, that provides for the prompt rescue of the user in the event of a fall, or assures that the user is able to rescue themselves. Store the Roofing Safety System in a cool, dry, clean environment, out of direct sunlight, when not in use.
PAGE 4
SWING FALLS SWING FALL HAZARD To minimize the possibility of a swing fall, anchor as directly above the work area as possible. Striking objects horizontally, due to the pendulum effect, may cause serious injury. Swing falls also increase the vertical fall distance of a worker, compared to a fall directly below the anchorage connector. Swing falls may be reduced by using overhead anchorage connectors that move with the worker.
PAGE 5
REQUIRED CLEARANCE USING AN ENERGY ABSORBING LANYARD IN A 12 FOOT FREE FALL APPLICATION Energy Absorbing 5 ft Lanyard To Worker’s Back D-Ring Free Fall Distance 11 ft Working Level 6 ft Length of Lanyard 5 ft Deceleration Free Fall Distance Total Estimated Required Clearance (from anchor) 19 ft 1 ft Harness Stretch 5 ft To Worker’s Back D-Ring Lower Level or Obstruction 2 ft Safety Factor CAUTION! If an energy absorbing lanyard is used in conjunction with a cross-arm anchorage connector, other anc
PAGE 6
CONNECTING TIE-BACK ENERGY ABSORBING LANYARDS WITHOUT A FLOATING D-RING Place the Tie-Back Energy Absorbing Lanyard over the qualified anchor and connect the tie-back snap hook directly to the webbing of the lanyard. Never attach the traditional snap hook to the webbing of the lanyard. Pull lanyard hand tight around anchor. Connect the energy absorbing end of the lanyard to the dorsal D-ring of the full body harness.
PAGE 7
• • • All snap hooks and carabiners on product must be able to self-close and lock. All hardware must be free of cracks, sharp edges, deformation, corrosion, or any evidence of defect. To inspect webbing, bend a 6 - 8 inch portion of the webbing into an upside down ‘U’ shape. Continue along all webbing and rope inspecting for tears, cuts, fraying, abrasion, discoloration, burns, holes, mold, pulled or broken stitches, or other signs of wear and damage.
PAGE 8
LABELS Labels Warning: User Capacity Range 130-310 lbs. Warning: User Capacity Range 130-400 lbs. 12ft. 1350lbs. 6ft. 1800lbs. Maximum Free Fall Maximum Arresting Force Maximum Deployment Distance 60" Forces may increase when cold and/or wet Read instructions Before Use Maximum Free Fall Maximum Arresting Force Maximum Deployment Distance 48" Read instructions Before Use Werner Co. Fall Protection 93 Werner Rd.