Use and Care Manual

7
Inspection & Maintenance
Inspect the units
housing for
damaged parts
Test the lifeline
retraction by pulling
it out several feet
and allowing it to
retract slowly
Test the breaking
mechanism by
applying a sharp
steady pull
downward
Inspect the snap
hook and
anchorage connection
for damage
Examine webbing
for excessive
fraying, cuts or
burns
Examine shock
packs for signs of
elongation
Examine snap
hooks for proper
action
Examine lifelines for
frays, cuts, and
tight braid
Examine beam
trollies for smoothly
moving parts,
distortion or
corrosion
Examine anchor for
operation and
broken components
Examine cross-arm
straps for excessive
fraying, cuts and
burns
Examine rings for
deformation or
corrosion
Examine rope grabs
for cam wear, pin
wear, distortion or
corrosion
Examine rope
for frayed ends,
excessive
wear, broken
components,
cuts and burns
Inspect for
cracks, burrs or
deformities.
Inspect for
corrosion, which
effects the
operation and/or
strength
Make sure certain
marking(s) are
legible
Self-Retracting
Lifeline
Lanyard Anchor Rope/Rope Grab Hook/Carabiner
A
A
C
B
D
Always refer to the manufacturer’s instruction for details on storage and maintenance
WebAlert inspectable polyester webbing makes wear and
damage visible and obvious making inspection easier.
A. Examine buckles and D ring for wear or corrosion
B. Examine webbing for excessive fraying, cuts or burns
C. Examine stitching for loose or torn threads
D. Examine grommets for looseness and deformities
Inspections should be recorded in a centralized logbook that includes the serial number, date of purchase, dates of
inspection, service work performed and authorized signatures. Werner does not specify a pre-determined shelf life for
fall protection products. Product life expectancy will be determined by routine inspection, conducted before each use by
the user and conducted at least semi-annually by a competent person per OSHA requirements. This process can begin
with the date of rst use of the product when it goes into service.