User Manual

11
EN
4. TO INSTALL THE BATTERY PACK (SEE FIG. E2)
Slide the fully charged battery pack onto the tool with
sufficient force until it clicks into position.
OPERATION
1. ON/OFF SWITCH (SEE FIG. F)
To start the machine, push the On/Off switch forward so
that the “1” mark is indicated on the switch.
To switch off the machine, push the On/Off switch toward
the rear so that the “O” mark is indicated on the switch.
2. VARIABLE SPEED CONTROL (SEE FIG. G)
Select oscillation frequency (speed) while the motor is
running.
The variable speed control can be used to set the optimum
oscillating frequency according to the accessories used and
the respective application.
High oscillation frequency: Sanding, sawing, rasping and
polishing stone and metal.
Low oscillation frequency: Polishing varnishes.
3. LED LIGHT (SEE FIG. H)
The LED light allows you to keep a clear view under less
illuminated circumstances. To turn on the light simply press
the on/off switch. When you release the on/off switch, the
light will be off.
4. SELECTING AN APPLICATION TOOL (SEE FIG. I)
Please observe the application tools intended for your
machine. Do not use these application tools are not intended
for this machine.
WORKING HINTS FOR YOUR CORDLESS
RECIPROCATING SAW
1. If your power tool becomes too hot, especially when
used at low speed, set the speed to maximum and
run it with no load for 2-3 minutes to cool the motor.
Avoid prolonged usage at very low speeds. Always
keep the blade sharp.
2. Always ensure the work-piece is firmly held or
clamped to prevent movement.
3. Any movement of the material may affect the quality
of the cutting or sanding finish.
4. Start your tool before working and turn it off only
after you stop working.
5. Do not start sanding without having the sandpaper
fitted.
6. Do not allow the sandpaper to wear away , it will
damage the sanding pad. The guarantee does not
cover sanding pad wear and tear.
7. Use coarse grit paper to sand rough surfaces,
medium grit for smooth surfaces and fine grit for
finishing surfaces. If necessary, first make a test run
on scrap material.
8. Excessive force will reduce the working efficiency
and cause motor overload. Replacing the accessory
regularly will maintain optimum working efficiency.
MAINTAINACE
Remove the battery pack from the tool before carrying
out any adjustment, servicing or maintenance.
Your power tool requires no additional lubrication or
maintenance.
There are no user serviceable parts in your power tool.
Never use water or chemical cleaners to clean your power
tool. Wipe clean with a dry cloth. Always store your power
tool in a dry place. Keep the motor ventilation slots clean.
Keep all working controls free of dust. Occasionally you may
see sparks through the ventilation slots. This is normal and
will not damage your power tool.
Remove the battery pack from the tool if the tool is not used
for more than 24 hours.
For Battery tools
The ambient temperature range for the use and storage of
tool and battery is 0
o
C (44.6
o
F) - 45
o
C (113
o
F).
The recommended ambient temperature range for the
charging system during charging is 0
o
C (44.6
o
F)-40
o
C
(104
o
F).