User`s manual

5. Place the Console Base (46) on the Uprights (11) (the
left Upright is not shown). Pull out just enough of the two
Wires (21) to connect them to the receptacles in the
Console Base. Make a loop with the indicated plastic tie
and insert the end through the tie holder on the bottom of
the Console Base. Locate the Wire that has a two-pin
connector and a three-pin connector. Plug the connectors
into the matching receptacles in the Console Base. If the
connectors do not fit easily, rotate them and then
plug them in. Slide the Wire Cover (107) onto the con-
nectors so that they are completely covered. Next, plug
the other Wire into the other receptacle on the Console
Base. Tighten the plastic tie and cut off the end. WARN-
ING: Do not connect or disconnect the Wires whilst
the treadmill power cord is plugged in.
See the inset drawing. Loop the included plastic tie around
the Wire Cover (107) so that the plastic tie is in the two
notches in the Wire Cover. Tighten the plastic tie and cut
off the end.
Tie
21
46
11
107
5
80
46
11
6
3. Refer to the inset drawing. If there is a plastic tie holding
the Cage Nut (70) in the Right Handrail (88), remove the
plastic tie. Feed the two Wires (21) in the right Upright (11)
up into the Right Handrail as shown. Using needlenose pli-
ers, pull the two Wires out of the indicated hole in the
Right Handrail.
Insert the bracket on the Right Handrail (88) into the
upper end of the right Upright (11), with the lower end of
the Right Handrail touching the side of the Extension Leg
(34) as shown. Hand tighten a Short Handrail Bolt (89)
with a Washer (39) into the upper end of the right Upright.
11
89
39
89
39
34
88
11
3
4. Attach the lower end of the Right Handrail (88) to the
Extension Leg (34) with a Handrail Bolt (91), a Handrail
Washer (92), and a Handrail Nut (93) as shown. Do not
tighten the Handrail Bolt yet. Note: If necessary, push
on the lower end of the Handrail to align the hole in the
Handrail with the hole in the Extension Leg.
Attach the Left Handrail to the left Extension Leg (not
shown) as described in steps 3 and 4.
4
92
91
93
34
88
6 11
HOW TO LOWER THE TREADMILL FOR USE
1. Hold the upper end of the treadmill with your right hand
as shown. Using your left thumb, press the storage latch
and hold it. Pivot the treadmill down until the frame and
the foot rail are past the storage latch.
2. Hold the treadmill firmly with both hands, and lower the
treadmill to the floor. Do not drop the treadmill frame to
the floor. To decrease the possibility of injury, bend
your legs and keep your back straight.
Unlatched
Storage
Latch
21
88
70
Tie
11
Tie
6. Thread four Screws (80) into the Uprights (11) and the
Console Base (46). After all four Screws have been
started, tighten the Screws until they are snug. Do
not overtighten the Screws.
107