User`s manual

TROUBLE-SHOOTING AND STORAGE

Most treadmill problems can be solved by following the simple steps below. Find the symptom that

applies to your treadmill and follow the steps listed. If further assistance is needed, please call our

Customer Service Department toll-free at 1-800-999-3756, Monday through Friday, 6 a.m. until 6 p.m.

Mountain Time (excluding holidays).

1. SYMPTOM: THE POWER DOES NOT TURN ON

a. Make sure that the power cord is plugged into a surge protector, and that the surge protector is plugged into

.. a properly grour_dedoutlet. (See HOW TO PLUG IN THE POWER CORD on page 7.) Use only a UL-listed

surge protector, rated at 15 amps, with a 14-gauge cord of five feet or less in length.

b. After the power cord has been plugged in, make sure that the SAFEKEY is fully inserted into the console.

(See page 9.)

c. Check the circuit breaker located on the treadmill frame near

the power cord. If the switch protrudes as shown, the circuit

breaker has tripped. To reset the circuit breaker, wait for five

minutes and then press the switch back in.

Tripped

Reset

2. SYMPTOM: THE POWER TURNS OFF DURING USE

a. Check the circuit breaker located on the treadmill frame near the power cord. Ifthe circuit breaker has

tripped, the switch will protrude. (See the drawing above.) To reset the circuit breaker, wait for five minutes

and then press the switch back in.

b. Make sure that the power cord is plugged in.

c. Remove the SAFEKEY from the console. Reinsert the SAFEKEY fully into the console.

3. SYMPTOM: THE DISPLAYS OF THE CONSOLE DO NOT FUNCTION PROPERLY

a. Check the batteries in the console. (See assembly step 5 on page 6). Most problems are the result of

drained batteries.

4. SYMPTOM: THE WALKING BELT SLOWS WHEN WALKED ON

a. Use only a UL-listed surge protector, rated at 15 amps, with a 14-gauge cord of five feet or less in length.

If the walking belt is overtightened, treadmill performance

maydecrease and the walking belt may be permanently dam-

aged. Remove the SAFEKEY and UNPLUG THE POWER

CORD. Using the included allen wrench, turn both rear roller

adjustment bolts counterclockwise, 1/4 of a turn. When the

walking belt is properly tightened, you should be able to lift

each side of the walking belt 2 to 3 inches off the walking

platforh_.The center of the walking belt should just touch the

walking platform. Be careful to keep the walking belt cen-

tered. Plug in the power cord, insert the SAFEKEY and run

the treadmill for a few minutes. Repeat until the walking belt

is properly tightened.

Rear Roller

Adjustment Bolts

2"-3"

c. If the walking belt stillslows when walked on, please call our Customer Service Department, toll-free.