User`s manual

5. SYMPTOM: THE WALKING BELT IS OFF-CENTER OR SLIPS WHEN WALKED ON
a. If the walking belt has shiftedto the left, first remove the
SAFEKEY and UNPLUG THE POWER CORD. Using the allen
wrench, turn the left rear roller adjustment bolt clockwise, and
the right bolt counterclockwise, 1/4 of a turn each. Be careful not
to overtighten the walking belt. Plug in the power cord, insert the
SAFEKEY and run the treadmill for a few minutes. Repeat until
the walking belt is.centered.
b. If the walking belt has shiftedto the right, first remove the
SAFEKEY and UNPLUG THE POWER CORD. Using the allen
wrench, turn the left rear roller adjustment bolt counterclockwise,
and the right bolt clockwise, 1/4 of a turn each. Be careful not to
overtighten the walking belt. Plug in the power cord, insert the
SAFEKEY and run the treadmill for a few minutes. Repeat until
the walking belt is centered.
c. If the walking belt slips when walked on, first remove the
SAFEKEY and UNPLUG THE POWER CORD. Using the allen
w:ench, tJrn both rear roller adjustment bolts clockwise, 1/4 of a
turn. When the walking belt is correctly tightened, you should be
able to lift each side of the walking belt 2 to 3 inches off the walk-
ing platform. The center of the walking belt should just touch the
walking platform. Be careful to keep the walking belt centered. Plug
in the power cord, insert the SAFEKEY and run the treadmill for a
few minutes. Repeat until the walking belt is properly tightened.
STORAGE
Unplug the power cord when the treadmill is not in use.
Remove the bolt and nut from the lower end of each handrail.
Remove the bolt from the upper end of each handrail. Slide the
handrails out of the console housing.
12
Remove the bolt and washer from the lower end of the upright. Lay
the upright on the treadmill. Keep all hardware in a secure location.
It is recommended that the batteries be removed from the console
and the treadmill be covered during extended periods of storage.
__ "7." ° ..o,_ move