ORDERING REPLACEMENT PARTS To order replacement parts, contact the ICON Fitness Lifestyle Ltd. office, or write: ICON Fitness Lifestyle Ltd.
¨ Class HC Fitness Product Model No. WETL26090 Serial No. Write the serial number in the space above for future reference. Serial Number Decal QUESTIONS? As a manufacturer, we are committed to providing complete customer satisfaction. If you have questions, or if there are missing parts, we will guarantee complete satisfaction through our Customer Service Department. Please CALL: 0345-089009 Or WRITE: ICON Fitness Lifestyle Ltd.
TABLE OF CONTENTS IMPORTANT PRECAUTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 BEFORE YOU BEGIN . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 ASSEMBLY . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 OPERATION AND ADJUSTMENT . . . . .
SUGGESTED STRETCHES The correct form for several basic stretches is shown in the drawings at the right. Move slowly as you stretchÑnever bounce. 1 1. Toe Touch Stretch Stand with your knees bent slightly and slowly bend forward from your hips. Allow your back and shoulders to relax as you reach down toward your toes as far as possible. Hold for 15 counts, then relax. Repeat 3 times. Stretches: Hamstrings, back of knees and back. 2 2. Hamstring Stretch Sit with one leg extended.
CONDITIONING GUIDELINES begin to use stored fat calories for energy. If your goal is to burn fat, adjust the speed and incline of the treadmill until your heart rate is near the low end of your training zone. (See pages 7 to 9.) WARNING: Before beginning this or any exercise program, consult your physician. This is especially important for individuals over the age of 35 or individuals with pre-existing health problems.
able to safely lift 45 pounds (20 kg) in order to raise, lower, or move the treadmill. 15. Never start the treadmill whilst you are standing on the walking belt. Always hold the handrails whilst using the treadmill. 21. When storing the treadmill, make sure that the storage latch is fully closed. 16. The treadmill is capable of high speeds. Adjust the speed in small increments to avoid sudden jumps in speed. 22. Inspect and tighten all parts of the treadmill every three months. 17.
BEFORE YOU BEGIN Thank you for selecting the WESLO¨ CADENCE 935 treadmill. The CADENCE 935 treadmill combines advanced technology with innovative design to let you enjoy an excellent form of cardiovascular exercise in the convenience and privacy of your home. And when youÕre not exercising, the unique CADENCE 935 can be folded up, requiring less than half the floor space of other treadmills. please call our Customer Service Department at 0345089009.
PROBLEM: The walking belt is off-centre or slips when walked on SOLUTION: a. If the walking belt has shifted to the left, first remove the key and UNPLUG THE POWER CORD. Using the allen wrench, turn the left rear roller adjustment bolt clockwise, and the right bolt counterclockwise, 1/4 of a turn each. Be careful not to overtighten the walking belt. Plug in the power cord, insert the key and run the treadmill for a few minutes. Repeat until the walking belt is centred. b.
MAINTENANCE AND TROUBLE-SHOOTING Most treadmill problems can be solved by following the steps below. Find the symptom that applies, and follow the steps listed. If further assistance is needed, please call our Customer Service Department. PROBLEM: The power does not turn on SOLUTION: a. Make sure that the power cord is plugged into a properly earthed outlet. (See HOW TO PLUG IN THE POWER CORD on page 7.) If an extension cord is needed, use only a 14-gauge cord of five feet (1,5m) or less in length. b.
ASSEMBLY Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. Note: The underside of the walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This does not affect treadmill performance.
3. Insert the bracket on the Left Handrail (61) into the left Upright (59). Whilst a second person holds the Console Base (52), carefully insert the Right Handrail (60) into the right Upright (59). Make sure that the lower ends of the Handrails (61, 60) are on the inside of the Base Legs (64) (refer to the inset drawing). 3 52 76 61 60 Bracket Loosely thread an Upright Bolt (48) with an Upright Washer (38) into each Upright (59). 48 38 59 59 Refer to the inset drawing.
HOW TO MOVE THE TREADMILL Before moving the treadmill, convert the treadmill to the storage position as described on page 10. Make sure that the storage latch is locked fully over the frame guide. 1. Hold the upper ends of the handrails. Place one foot on one of the front wheels as shown. 2. Tilt the treadmill back until it rolls freely on the front wheels. Carefully move the treadmill to the desired location. Never move the treadmill without tipping it back, or the base pads may come off.
HOW TO SELECT KILOMETRES AND MILES Console The console can display distance and speed in either kilometres or miles. To change the unit of measurement, first UNPLUG THE POWER CORD. Next, remove the six screws attaching the console to the console base. Lift the console a few inches, being careful not to pull on the wires, and turn the console over. Locate the small switch on the back of the console. Move the switch upward or downward to select kilometres or miles. Re-attach the console to the console base.
OPERATION AND ADJUSTMENT THE PERFORMANT LUBETM WALKING BELT Your treadmill features a walking belt coated with PERFORMANT LUBETM, a high-performance lubricant. IMPORTANT: Never apply silicone spray or other substances to the walking belt or the walking platform. They will deteriorate the walking belt and cause excessive wear. HOW TO PLUG IN THE POWER CORD This product must be earthed.
DIAGRAM OF THE CONSOLE Monitor Display Display Button Speed Control Pulse Display Mode Button Clip Key Pulse Sensor Follow the steps below to operate the console. CAUTION: Before operating the console, read the following precautions. 1 Insert the key fully into the power switch. Note: Inserting the key will not turn on the displays. The displays will turn on when the display button is pressed or when the walking belt is started. If you just installed batteries, the displays will already be on.
3 Follow your progress with the monitor display. 4 The monitor display offers six modes that provide instant exercise feedback: Measure your pulse, if desired. When you are not Pulse using the pulse Sensor sensor, a ÒPÓ will appear in the pulse display. To measure your pulse, stand on the foot rails and place your thumb on the pulse sensor as shown. The pulse sensor is pressure activatedÑfully press it down.
PART LISTÑModel No. WETL26090 Key No. Qty.
REMOVE THIS EXPLODED DRAWING AND PART LIST FROM THE MANUAL 34 Save this EXPLODED DRAWING and PART LIST for future reference. Note: Specifications are subject to change without notice. For information about ordering replacement parts, see the back cover of the UserÕs Manual.
11 EXPLODED DRAWINGÑModel No.
11 11 16* 4 11 49 51 25 55 52* 17 54 96 47 32 56 11 22 30 15 47 21 41 24 92 49 19 20 18 75 46 44 80 29 36 33 22 11 72 23 28 22 38 76 37 49 45 89 42 80 27 91 72 47 47 34 23 90 48 31 21 84 38 11 47 43 46 48 58 38 26 22 39 7 83 82 21 22 57 22 44 85 62 13 60 79 61 22 84 59 39 13 87 49 5 86 13 88 69 4 38 13 66 62 65 71 70 67 70 63 9 40 67 22 9 70 69 74 67 22 66 76 22 64 2 64 79 2 38 63 77 1 3 65 73 73 2 6 22 79
