User`s manual

The Console (1) requires two "AAA" batteries; alkaline

batteries are recommended, Press the indicated tab on

the Battery Cover (27), and remove the Battery Cover.

Insert two batteries into the two battery clips; make

sure that the negative (-) ends of the batteries are

touching the springs in the battery clips.

attere

See drawing 7a. Hold the Console (1) near the

Handrail (5), Connect the wire on the Console to the

Handrail Wire (2), Then, attach the Console to the

Handrail with two M4 x 12mm Screws (3). Make sure

that the wires are not pinched.

See drawing 7b. Press the Battery Cover (27) onto the

Console (1).

Remove the paper backing from the Adhesive Clip (30).

Press the Adhesive Clip onto the left side of the Frame

(29) in the indicated location. Then, press the Hex Key

(20) into the Adhesive Clip.

Make sure that the walking belt is properly tightened

(see SYMPTOM 3 on page 12).

9. Make sure that all parts are properly tightened before you use the treadmill. To protect the floor or car-

pet, place a mat under the treadmill.