Model No. SPRW52464 Serial No. Write the serial number in the space above for reference. Serial Number Decal QUESTIONS? As a manufacturer, we are committed to providing complete customer satisfaction. If you have questions, or find that there are missing or damaged parts, we will guarantee complete satisfaction through direct assistance from our factory. TO AVOID UNNECESSARY DELAYS, PLEASE CALL DIRECT TO OUR TOLL-FREE CUSTOMER HOT LINE.
TABLE OF CONTENTS LIMITED WARRANTY . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2 IMPORTANT SAFETY INSTRUCTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3 WARNING DECAL PLACEMENT . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5 BEFORE YOU BEGIN . . . . . . . . . . . . . . . . . . . . . .
IMPORTANT SAFETY INSTRUCTIONS WARNING: To reduce the risk of drowning, electric shock, or serious injury, read the following important precautions before using the DAYBREAK. READ AND FOLLOW ALL INSTRUCTIONS 1. It is the responsibility of the owner to ensure that all users of the DAYBREAK are adequately informed of all precautions. 13. Keep all chemicals away from children and pets. 14. The pH and chemical balance of the water must be maintained as explained in this manual (see page 15).
20. Keep all electrical appliances such as radios, telephones, televisions, and lights at least five feet (1.52 meters) away from the water. 27. WARNINGÑTo reduce the risk of injury: Pregnant women should consult with their physician before using the DAYBREAK. Pregnant women should not use the DAYBREAK if the water temperature is above 100¡F (38¡C); the unborn child could be seriously harmed. 21. A wire connector is provided on the pump motor of this unit to connect a minimum No.
WARNING DECAL PLACEMENT The decals shown below have been placed on the DAYBREAK. If a decal is missing, or if it is not legible, please call our Customer Service Department toll-free at 1-800-999-3756, Monday through Friday, 6 a.m. until 6 p.m. Mountain Time, to order a replacement decal. Apply the decal in the location shown.
BEFORE YOU BEGIN Thank you for selecting the DAYBREAK by WESLO¨. The innovative DAYBREAK offers the features and quality of a traditional hot tub at an affordable price. Best of all, the DAYBREAK is fully portable, so you can take it wherever there is an electrical outlet. The DAYBREAK allows you to relax and unwind in the comfort of your own home. Department toll-free at 1-800-999-3756, Monday through Friday, 6 a.m. until 6 p.m. Mountain Time (excluding holidays).
CHOOSING A LOCATION FOR THE DAYBREAK There are many factors to consider when choosing a location to set up the DAYBREAK. These factors vary depending on whether you use the DAYBREAK inside or outside. We have listed several factors you may wish to consider as you decide where you want to use the DAYBREAK. If you set up the DAYBREAK inside: If you set up the DAYBREAK outside: 1. The DAYBREAK will increase the level of humidity in your home. The location you choose should be well ventilated.
ASSEMBLY Before beginning assembly, carefully read the following information and instructions: ¥ Read each assembly step before you begin. ¥ During assembly, make sure that all parts are oriented as shown in the drawings. ¥ Place all parts in a cleared area and remove the packing materials; do not dispose of the packing materials until assembly is completed. TOOLS REQUIRED FOR ASSEMBLY: ¥ Your own phillips screwdriver ¥ Assembly requires two people.
4. Place the Insulated Floor Cover (8) inside the assembled Side Panels (1). The edge of the Insulated Floor Cover should cover the bottom two inches of the Side Panels (see the inset drawing). 4 1 8 8 Measure the width of the DAYBREAK, from the top center of one Side Panel (1) to the top center of the Side Panel directly across from it. Take two measurements, as shown. Both measurements must be the same. The measurement should be between 56Ó and 58Ó.
8. Before you fill the DAYBREAK, be sure that it is in the position you want, and that it can be easily serviced, if needed. Once the DAYBREAK is filled with water, it will need to be drained to be moved. 8 Using a garden hose or other clean water source, begin filling the DAYBREAK. Be sure to check for wrinkles, which may form in the Spa Liner (9) as the water begins to cover the bottom. It is very important that you remove as many wrinkles from the floor and sides of the DAYBREAK as possible.
10. Place the Spa Cover (11) over the Side Panels (1) and the Spa Jet Unit (13). Be sure that the Spa Cover is properly centered and that the corners of the Spa Cover line up with the corners of the Side Panels (1). 10 Strap Latch 23 Snap a Buckle (21) onto each of the seven latches on the Spa Cover (11). 21 See the inset drawing. Position one of the Buckles (21) on the Side Panel (1) and hold the Buckle in place, so the strap on the Spa Cover (11) is tight.
USING THE DAYBREAK The DAYBREAK is designed for up to four adults. The six water jets can be regulated to provide a relaxing massage to sooth away stress, and the strength of the water massage can be adjusted by the air control. The DAYBREAK holds 170 gallons of water and offers an automatic, programmable heating (70¡F to 104¡F) and filtration system. or more amps. No other appliance should be on the same circuit. Replace the power cord immediately if it becomes damaged.
be obtained at a pool and spa supply store. The pH reading should be between 7.2 and 7.8. SECURING THE SPA COVER The spa cover can be secured by snapping the latches on the spa cover into the buckles on the side panels. If the level is too low, add half of one of the ÒQUICK pHix It UPÓ packets to the water. Let the water circulate through the spa jet unit for five minutes. Test the pH level again. Repeat until the pH level is correct.
SPA JET UNIT OPERATION ing the water for twenty minutes to filter any impurities. Also, if the water temperature falls below 40¡F, the pump will begin circulating and heating the water to prevent the water from freezing. The spa jet unit features five hydro-therapy jets, a whirlpool diverter, a suction vent, and a filter housing. The five hydro-therapy jets (A), located on the front of the spa jet unit, focus the water massage on your neck and back.
MAINTENANCE CLEANING THE SPA LINER 4. Keep all chemicals out of the reach of children and pets. 5. Keep all containers closed tightly when not in use. 6. Never add water to the chemicalsÑalways add the chemicals to the water as directed. 7. Always store chemicals in a cool, dry place. 8. Always keep chemicals away from children and pets. The liner should be cleaned with a mild soap solution. Do not use solvents. The liner should always be clean and dry before being moved or stored.
TROUBLE-SHOOTING Most problems can be solved by following the simple steps below. Find the symptom that applies, and follow the steps listed. If further assistance is needed, call our Customer Service Department toll-free at 1-800-999-3756, Monday through Friday, 6 a.m. until 6 p.m. Mountain Time. 1. SYMPTOM: THE SPA WILL NOT OPERATE 6. SYMPTOM: THE WATER DOES NOT HEAT a. Check the power cord. The power cord must be plugged into a grounded outlet (see PLUGGING IN THE DAYBREAK on page 12). a.
b. A clamp or seal inside the spa jet may be loose. Check the floor around the spa jet unit for excess water, and watch the spa jet unit while it is operating to see if water drips from the spa jet unit housing. If you can identify the location of the leak inside the spa jet unit, tighten the clamp or replace the damaged seal. 10. SYMPTOM: THE SPA JET UNIT CONTINUES TO RUN AFTER IT HAS BEEN SHUT OFF a. To turn the spa jet unit on, press the ON/OFF control once.
PART LISTÑModel No. SPRW52464 Key No. Qty. 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 8 8 8 64 16 8 4 1 1 4 1 7 1 1 1 1 1 1 1 1 4 1 8 1 1 1 1 4 1 4 4 1 Description R0198A Key No. Qty.
EXPLODED DRAWINGÑModel No.
ORDERING REPLACEMENT PARTS To order replacement parts, simply call our Customer Service Department toll-free at 1-800-999-3756, Monday through Friday, 6 a.m. until 6 p.m. Mountain Time (excluding holidays). To help us assist you, please be prepared to give the following information when calling: 1. The MODEL NUMBER of the product (SPRW52464). 2. The NAME of the product (DAYBREAK by WESLO¨). 3. The SERIAL NUMBER of the product (see the front cover of this manual). 4.
