Model No. WATL27205.1 Serial No. USER'S MANUAL Serial Number Decal QUESTIONS? If you have questions, or if there are missing or damaged parts, we will guarantee complete satisfaction through direct assistance from our factory. TO AVOID DELAYS, PLEASE CALL DIRECT TO OUR TOLLFREE CUSTOMER HOT LINE. The trained technicians on our Customer Hot Line will provide immediate assistance, free of charge to you. CUSTOMER HOT LINE: 800-820-0915 E-mail: newlife@vip.163.com ICON’s Web site: www.iconfitness.
TABLE OF CONTENTS IMPORTANT PRECAUTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3 BEFORE YOU BEGIN . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5 ASSEMBLY . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
IMPORTANT PRECAUTIONS WARNING: To reduce the risk of burns, fire, electric shock, or injury to persons, read the following important precautions and information before operating the treadmill. 13. Never move the walking belt while the power is turned off. Do not operate the treadmill if the power cord or plug is damaged, or if the treadmill is not working properly. (See TROUBLESHOOTING on page 17 if the treadmill is not working properly.) 1.
24. DANGER: Always unplug the power other than the procedures in this manual should be performed by an authorized service representative only. cord immediately after use, before cleaning the treadmill, and before performing the maintenance and adjustment procedures described in this manual. Never remove the motor hood unless instructed to do so by an authorized service representative. Servicing 25. This treadmill is intended for in-home use only.
BEFORE YOU BEGIN Thank you for selecting the new WESLO® E-30 treadmill. The E-30 treadmill offers an impressive array of features designed to help you achieve your fitness goals in the convenience and privacy of your home. And when you’re not exercising, the unique E-30 treadmill can be folded up, requiring less than half the floor space of conventional treadmills. ing this manual, see the front cover of this manual.
ASSEMBLY Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill performance.
3. Hold an Upright Spacer (59) against one side of the Frame (96) as shown. Insert a 4” Frame Bolt (54) into the indicated hole in the Upright Spacer and the Frame. Next, tighten a 3/4” Tek Screw (9) into the Upright Spacer and the Frame. Then, remove the 4” Frame Bolt. Repeat this procedure on the other side of the Frame. 3 104 55 12 9 54 59 96 Have a second person lift the front end of the Frame (96).
6. Attach the end of the ground wire to the small hole in the side of the Right Handrail (40) with a Silver Ground Screw (66). 6 66 Ground Wire 40 7. Set the console assembly onto the Left and Right Handrails (13, 40). Be careful not to pinch the Wire Harness (65). Tighten two Pulse Bar Screws (37), with two #10 Star Washers (108), through the brackets on the Handrails and into the Pulse Bar (39). Do not tighten the Pulse Bar Screws yet. 7 Console Assembly 13 40 65 108 108 37 8.
. Press the Wire Harness (65) into the indicated track in the Console Base (67). (Note: If there is a cylinder on the Wire Harness that will not fit into the track, press as much of the Wire Harness as possible into the track.) Next, insert the excess Wire Harness into the large hole in the side of the Right Handrail (40). Securely tighten the nylon tie to prevent the Wire Harness from slipping, and then cut off the end of the nylon tie.
OPERATION AND ADJUSTMENT THE PRE-LUBRICATED WALKING BELT Your treadmill features a walking belt coated with high-performance lubricant. IMPORTANT: Never apply silicone spray or other substances to the walking belt or the walking platform. Such substances will deteriorate the walking belt and cause excessive wear. HOW TO PLUG IN THE POWER CORD This product must be earthed.
Clip Key FEATURES OF THE CONSOLE To use the manual mode of the console, follow the steps beginning on page 12. To use a preset program, see page 14. The treadmill console offers a selection of features designed to make your workouts more effective and enjoyable. When the manual mode of the console is selected, the speed and incline of the treadmill can be changed with the touch of a button. As you exercise, the displays will provide continuous exercise feedback.
HOW TO TURN ON THE POWER Plug in the power cord (see page 11). Next, locate the on/off switch on the right side of the treadmill frame near the right upright. Make sure that the switch is in the “on” position. As you exercise, change the speed of the walking belt as desired by pressing the Speed increase and decrease buttons. Each time a button is pressed, the speed setting will change by 0.1 mph. If a button is held down, the speed setting will change in increments of 0.5 mph.
Incline display—This display shows the incline level of the treadmill. that the walking belt has moved, and the Time/Pace display will show the total number of hours that the treadmill has been used. Time/Pace display— When the manual mode is selected, this display will show the elapsed time and your Indicator pace (pace is measured in minutes per mile or minutes per kilometer). The display will alternate between one number and the other every few seconds, as shown by the indicators in the display.
7 Listen to your favorite FM radio station if desired. HOW TO USE A PRESET PROGRAM Press the Power button to turn on the radio. Next, press the Tune buttons to select the desired FM radio station. Then, press the Volume buttons to adjust the volume of the speakers. Note: A pair of headphones (not included) can be plugged into the headphone jack. Power Button Memory Buttons 1 See HOW TO TURN ON THE POWER on page 12. 2 Select one of the eight preset programs.
When only three seconds remain in the first segment of the program, both the Current Segment column and the column to the right will flash, and a series of tones will sound. If the speed and/or incline of the treadmill is about to change, the Incline display and/or the Speed display will flash to alert you. When the first segment ends, all speed settings in the matrix will move one column to the left.
HOW TO FOLD AND MOVE THE TREADMILL HOW TO FOLD THE TREADMILL FOR STORAGE Before folding the treadmill, adjust the incline to the lowest position. If this is not done, the treadmill may be permanently damaged. Next, unplug the power cord. CAUTION: You must be able to safely lift 20 kg (45 lbs.) to raise, lower, or move the treadmill. 1. Hold the treadmill with your hands in the location shown by the arrow at the right. To decrease the possibility of injury, bend your legs and keep your back straight.
TROUBLESHOOTING Most treadmill problems can be solved by following the steps below. Find the symptom that applies, and follow the steps listed. If further assistance is needed, please see the front cover of this manual. PROBLEM: The power does not turn on SOLUTION: a. Make sure that the power cord is plugged into a properly earthed outlet (see page 10). If an extension cord is needed, use only a 3-conductor, 1mm2 (14-gauge) cord that is no longer than 1.5 m (5 ft.).
Locate the Reed Switch (16) and the Magnet (10) on the left side of the Pulley (101). Turn the Pulley until the Magnet is aligned with the Reed Switch. Make sure that the gap between the Magnet and the Reed Switch is about 3 mm (1/8 in.). If necessary, loosen the indicated 3/4” Tek Screws (9), move the Reed Switch slightly, and then retighten the Screw. Reattach the Hood (not shown), and run the treadmill for a few minutes to check for a correct speed reading.
CONDITIONING GUIDELINES WARNING: Before beginning this or any exercise program, consult your physician. This is especially important for individuals over the age of 35 or individuals with preexisting health problems. The pulse sensor is not a medical device. Various factors, including the user’s movement, may affect the accuracy of heart rate readings. The pulse sensor is intended only as an exercise aid in determining heart rate trends in general.
PART IDENTIFICATION CHART Remove this chart and use it to identify small parts during assembly. Save this chart and the EXPLODED DRAWING/PART LIST for future reference.
PART LIST—Model No. WATL27205.1 Key No. Qty.
95 89 91 44 94 109 98 41 107 112 88 9 50 48 2 90 33 90 94 44 92 9 6 1 93 64 80 35 114 75 102 95 97 90 21 82 76 64 9 7 9 3 113 76 4 92 50 5 9 91 9 9 89 6 9 109 100 9 7 92 11 101 111 16 10 96 7 9 99 59 18 19 9 3 9 6 15 86 52 14 17 56 21 7 4 24 22 5 8 9 44 9 86 21 25 51 23 24 94 6 83 44 81 9 110 9 8 9 105 32 103 38 87 9 59 27 26 20 53 49 105 39 27 28 34 61 85 27 45 13 64 79 58 57 55 54 27
HOW TO ORDER REPLACEMENT PARTS To order replacement parts, contact our Customer Service Department or write: Shanghai Newlife Fitness Equipment, Inc. Customer Service Department Room 504, No. 16, Lane 1030 YanAn West Road Shanghai, 200052, PR China Tel: 800-820-0915 Before calling, please note the following information: • the MODEL NUMBER of the product (WATL27205.
