User`s manual

6. AttachtheSeat(12)totheSeatFrame(3)withfour

M6x 16mmZincScrews(57).

7. TheConsole(16)requirestwoAAbatteries(notinclud-

ed).Alkalinebatteriesarerecommended.Referto the

insetdrawing.Removethebatterycoverfromtheback

of theConsole,andinserttwoAAbatteriesintothe

Console.Make sure that the negative ends of the

batteries (marked "-") are touching the springs in

the Console. Reattach the battery cover.

Next, plug the Reed Switch Wire (43) into the back of

the Console (16). Carefully slide the Console onto the

indicated tab on the Frame (1). Note: The Console is

held by friction; it does not snap into place.

Press the Resistance Knob (14) onto the Resistance

Control (13).

8. Identify the Left Pedal (24), which is marked with an

"L." Using an adjustable wrench, firmly tighten the

Left Pedal counterclockwise into the left arm of the

Crank (27). Tighten the Right Pedal (26) clockwise into

the right arm of the Crank. Important: Tighten both

Pedals as firmly as possible. After using the

crosstrainer for one week, retighten the Pedals. For

best performance, the Pedals must be kept tight-

ened.

Refer to HOW TO ADJUST THE PEDAL STRAPS on

page 7 and adjust the Left Pedal Strap (65) to the

desired position. Adjust the Right Pedal Strap (66) in

the same way.

Batteries

9. Make sure that all parts of the crosstrainer are properly tightened. Note: Some hardware may be left

over after assembly is completed. To protect the floor or carpet from damage, place a mat under the

crosstrainer.