Model No. WATL16105.0 Serial No. Serial Number Decal USER'S MANUAL QUESTIONS? If you have questions, or if any parts are missing or damaged, PLEASE CONTACT OUR CUSTOMER SERVICE DEPARTMENT DIRECTLY. Call toll-free: 800-830-7240 E-mail: service@goodfamily.cc Goodfamily’s Web site: www.goodfamily.cc ICON’s Web site: www.iconfitness.com CAUTION Read all precautions and instructions in this manual before using this equipment. Save this manual for future reference.
TABLE OF CONTENTS IMPORTANT PRECAUTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3 BEFORE YOU BEGIN . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5 ASSEMBLY . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
IMPORTANT PRECAUTIONS WARNING: To reduce the risk of burns, fire, electric shock, or injury to persons, read the following important precautions and information before operating the treadmill. 1. It is the responsibility of the owner to ensure that all users of this treadmill are adequately informed of all warnings and precautions. 12. Failure to use a properly functioning surge suppressor could result in damage to the control system of the treadmill.
22. Inspect and properly tighten all parts of the treadmill regularly. scribed in this manual. Never remove the motor hood unless instructed to do so by an authorized service representative. Servicing other than the procedures in this manual should be performed by an authorized service representative only. 23. Never drop or insert any object into any opening. 24. DANGER: Always unplug the power 25. This treadmill is intended for in-home use only.
BEFORE YOU BEGIN Thank you for selecting the WESLO® A-40 treadmill. The A-40 treadmill combines advanced technology with innovative design to let you enjoy an excellent form of cardiovascular exercise in the convenience and privacy of your home. And when you’re not exercising, the unique A-40 treadmill can be folded up, requiring less than half the floor space of other treadmills. ing this manual, please see the front cover of this manual.
ASSEMBLY Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not remove the long wire inside of the right handrail yet. In addition, do not dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This does not affect treadmill performance.
3. With the help of a second person, raise the Handrails (6, 7) so the Base (71) is flat on the floor. 3 7 6 Attach the Wheels (15) to the outer sides of the Base (71) with two Wheel Bolts (14) and two Nuts (17). Do not overtighten the Nuts; the Wheels should turn freely. 17 55 Position the treadmill Frame (55) between the Handrails (6, 7) as shown. See the inset drawing. Locate the wire in the lower end of the Right Handrail (6).
6. Set the Console (1) on the Right Handrail (6) and the Left Handrail (not shown). Start four Console Screws (70) (only two are shown) into the Console. After you have started all four Console Screws, tighten them. 6 1 Insert the excess Wire Harness (22) down into the Right Handrail (6). Tighten the three plastic ties around the Wire Harness, and then cut off the ends of the plastic ties. 22 Plastic Ties 70 6 7. Attach the Console Back (4) to the Console (1) with four 16mm Screws (87).
OPERATION AND ADJUSTMENT THE PRE-LUBRICATED WALKING BELT Your treadmill features a walking belt coated with high-performance lubricant. IMPORTANT: Never apply silicone spray or other substances to the walking belt or the walking platform. Such substances will deteriorate the walking belt and cause excessive wear. HOW TO PLUG IN THE POWER CORD This product must be earthed.
DIAGRAM OF THE CONSOLE Note: If there is a sheet of clear plastic on the console, remove the plastic. Clip Key CAUTION: Before operating the console, read the following precautions. • Do not stand on the walking belt when turning on the power. • Always wear the clip (see the drawing above) while operating the treadmill. • Adjust the speed in small increments to avoid sudden jumps in speed. Next, stand on the foot rails of the treadmill.
To stop the walking belt, press the Stop button. If the elapsed time is shown in the display (see step 3), the time will begin to flash. 4 Step onto the foot rails, press the Stop button, and remove the key from the console. Keep the key in a secure place. Then, switch the reset/off circuit breaker to the “off” position and unplug the power cord. Note: The first time the treadmill is used, observe the alignment of the walking belt, and center the walking belt if necessary (see page 14).
HOW TO FOLD AND MOVE THE TREADMILL HOW TO FOLD THE TREADMILL FOR STORAGE 1 Unplug the power cord. CAUTION: You must be able to safely lift 20 kg (45 lbs.) to raise, lower, or move the treadmill. 1. Hold the metal frame firmly in the location shown by the arrow at the right. CAUTION: To decrease the possibility of injury, do not lift the frame by the plastic foot rails. Make sure to bend your legs and keep your back straight. As you raise the frame, make sure to lift with your legs rather than your back.
MAINTENANCE AND TROUBLESHOOTING Most treadmill problems can be solved by following the steps below. Find the symptom that applies, and follow the steps listed. If further assistance is needed, please see the front cover of this manual. PROBLEM: The power does not turn on SOLUTION: a. Make sure that the power cord is plugged into a properly earthed outlet. (See page 9.) If an extension cord is needed, use only a 3-conductor, 1 mm2 (14-gauge) cord that is no longer than 1.5 m (5 ft.).
PROBLEM: The walking belt slows when walked on SOLUTION: a. If an extension cord is needed, use only a 3-conductor, 1mm2 (14-gauge) cord that is no longer than 1.5 m (5 ft.). b. If the walking belt is overtightened, treadmill performance may decrease and the walking belt may become damaged. Remove the key and UNPLUG THE POWER CORD. Using the hex key, turn both rear roller bolts counterclockwise, 1/4 of a turn.
CONDITIONING GUIDELINES is activity that requires large amounts of oxygen for prolonged periods of time. This increases the demand on the heart to pump blood to the muscles, and on the lungs to oxygenate the blood. For aerobic exercise, adjust the speed and incline of the treadmill until your heart rate is near the highest number in your training zone. WARNING: Before beginning this or any exercise program, consult your physician.
PART LIST—Model No. WATL16105.0 Key No. Qty.
2 3/4” Bolt (47)–4 Star Washer (81)–4 Washer (29)–4 Handrail Washer (11)–2 PART IDENTIFICATION CHART 4” Bolt (120)–2 Remove this chart and use it to identify small parts during assembly. Save this chart and the EXPLODED DRAWING/PART LIST for future reference.
51 64 63 20 85 83 75 21 85 67 11 45 20 24 66 86 51 47 52 84 67 29 28 75 26 63 45 27 11 47 84 16 85 52 76 69 20 72 78 52 66 86 37 52 64 85 57 83 52 20 54 31 77 52 52 49 48 55 56 46 75 53 69 68 50 5 43 76 31 59 61 36 39 58 33 26 9 27 68 52 34 5 79 58 9 80 77 20 38 39 20 8 20 35 25 5 62 32 82 8 74 23 5 20 74 8 18 20 40 73 3 8 88 73 40 44 89 30 10 87 19 42 7 87 19 42 60 41 4 17 15 13 70 2 42 2 1
ORDERING REPLACEMENT PARTS To order replacement parts, call our Customer Service Department toll-free at 800-830-7240, or call: Beijing: 010-60291670 Guizhou: 0851-5617855 Shengang: 024-22507779 Changchun: 0431-682499 Ha’erbin: 0451-82702754 Shenzhen: 0755-83248325 Changsha: 0731-4825618 Hefei: 0551-4238040 Shijiazhuang: 0311-86219246 Chengdu: Jinan: 0531-86292209 Wuhan: 027-87275455 Chongqing: 023-65457730 Kunming: 0871-3130512 Xi’an: 029-87891305 Dongquan: 0769-2333575 Nanjing:
