Model No. WCTL28090 Serial No. Write the serial number in the space above for future reference. ® Serial Number Decal QUESTIONS? USER'S MANUAL As a manufacturer, we are committed to providing complete customer satisfaction. If you have questions, or find that there are missing or damaged parts, we will guarantee you complete satisfaction through direct assistance from our factory. TO AVOID UNNECESSARY DELAYS, PLEASE CALL DIRECT TO OUR TOLL-FREE CUSTOMER HOT LINE.
TABLE OF CONTENTS IMPORTANT PRECAUTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 BEFORE YOU BEGIN . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 ASSEMBLY . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 OPERATION AND ADJUSTMENT . . . . .
15. The treadmill is capable of high speeds. Adjust the speed in small increments to avoid sudden jumps in speed. lower, or move the treadmill. 20. When storing the treadmill, make sure that the storage latch is fully closed. 16. The pulse sensor is not a medical device. Various factors, including the user's movement, may affect the accuracy of heart rate readings. The pulse sensor is intended only as an exercise aid in determining heart rate trends in general. 21.
BEFORE YOU BEGIN Thank you for selecting the WESLO® CADENCE 1020 treadmill. The CADENCE 1020 treadmill combines advanced technology with innovative design to let you enjoy an excellent form of cardiovascular exercise in the convenience and privacy of your home. And when you’re not exercising, the unique CADENCE 1020 can be folded up, requiring less than half the floor space of other treadmills. at 1-888-936-4266, Monday through Friday, 8 a.m. until 6:30 p.m. Eastern Standard Time (excluding holidays).
ASSEMBLY Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. Assembly requires the included allen wrench and your own phillips screwdriver and scissors . 1. Note that the Right Handrail (32) and the Console Base (not shown) are connected to the treadmill by the Wire Harness (53). During assembly steps 1 through 5, be careful to avoid pulling on or damaging the Wire Harness.
4. Attach a Handrail Cover (63) and the Left Handrail (4) to the left Upright (38) with two Handrail Knobs (1) and two Knob Washers (13). Do not tighten the Handrail Knobs yet. If you are shorter than 5’ 8”, use the upper two holes in the Handrail; if you are 5’ 8” or taller, use the lower two holes. 4 87 53 32 4 Have a second person hold the Console Base (87) and the Right Handrail (32) in the position shown.
OPERATION AND ADJUSTMENT THE PERFORMANT LUBETM WALKING BELT risk of electric shock. This product is equipped with a cord having an equipment-grounding conductor and a grounding plug. Plug the power cord into a surge protector, and plug the surge protector into an appropriate outlet that is properly installed and grounded in accordance with all local codes and ordinances. Your treadmill features a walking belt coated with PERFORMANT LUBETM, a high-performance lubricant.
DIAGRAM OF THE CONSOLE Displays Incline Control Display On/Reset Button Pulse Sensor Speed Control Key Clip Follow the steps below to operate the console. CAUTION: Before operating the console, read the following precautions. 1 • Do not stand on the walking belt when turning on the power. Insert the key fully into the power switch. Note: Inserting the key will not turn on the displays. The displays will turn on when the display on/reset button is pressed or when the walking belt is started.
3 shown. Hold your thumb on the sensor for another 15 seconds for the most accurate reading. Follow your progress with the four displays. TIME display—This display shows the elapsed time. If the displayed pulse appears to be too high or too low, or if your pulse is not displayed, lift your thumb off the sensor and allow the display to reset. Press down again on the sensor as described above.
HOW TO FOLD AND MOVE THE TREADMILL HOW TO FOLD THE TREADMILL FOR STORAGE Before folding the treadmill, unplug the power cord. Caution: You must be able to safely lift 45 pounds in order to raise, lower, or move the treadmill. 1. Hold the treadmill with your hands in the locations shown at the right. To decrease the possibility of injury, bend your legs and keep your back straight. As you raise the treadmill, make sure to lift with your legs rather than your back.
HOW TO LOWER THE TREADMILL FOR USE 1. Hold the upper end of the treadmill with your right hand as shown. Using your left thumb, slide open the storage latch and hold it open. Pivot the treadmill until the frame is past the storage latch. Storage Latch Frame Guide 2. Hold the treadmill firmly with both hands, and lower the treadmill to the floor. To decrease the possibility of injury, bend your legs and keep your back straight.
MAINTENANCE AND TROUBLE-SHOOTING Most treadmill problems can be solved by following the steps below. Find the symptom that applies, and follow the steps listed. If further assistance is needed, please call our Customer Service Department tollfree at 1-888-963-4266, Monday through Friday, 8 a.m. until 6:30 p.m. Eastern Standard Time (excluding holidays). PROBLEM: The power does not turn on SOLUTION: a.
PROBLEM: The walking belt is off-center or slips when walked on SOLUTION: a. If the walking belt has shifted to the left, first remove the key and UNPLUG THE POWER CORD. Using the allen wrench, turn the left rear roller adjustment bolt clockwise, and the right bolt counterclockwise, 1/4 of a turn each. Be careful not to overtighten the walking belt. Plug in the power cord, insert the key and run the treadmill for a few minutes. Repeat until the walking belt is centered. b.
CONDITIONING GUIDELINES gy. Only after the first few minutes does your body begin to use stored fat calories for energy. If your goal is to burn fat, adjust the speed and incline of the treadmill until your heart rate is near the low end of your training zone. (See pages 8 and 9.) WARNING: Before beginning this or any exercise program, consult your physician. This is especially important for individuals over the age of 35 or individuals with pre-existing health problems.
ORDERING REPLACEMENT PARTS To order replacement parts, simply call our Customer Service Department toll-free at 1-888-963-4266, Monday through Friday, 8 a.m. until 6:30 p.m. Eastern Standard Time (excluding holidays).
PART LIST—Model No. WCTL28090 Key No. Qty. 1 2 3 4 5 6 7 8 9 10 11* 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 4 4 2 1 1 1 1 10 1 1 1 2 4 4 0 2 1 1 3 1 1 1 1 1 1 1 1 12 1 1 12 1 4 1 1 2 2 1 2 15 2 2 7 2 1 1 1 1 1 1 4 1 1 R0201A Description Key No. Qty.
REMOVE THIS EXPLODED DRAWING AND PART LIST FROM THE MANUAL 34 Save this EXPLODED DRAWING and PART LIST for future reference. Note: Specifications are subject to change without notice. For information about ordering replacement parts, see the back cover of the User’s Manual.
85 76 51 28 28 5 36 55 9 76 37 28 10 56 51 80 56 76 88 89 95 8 61 51 54 43 28 12 93 90 44 67* 11* 92 76 59 60 56 91 40 33 31 20 95 57 44 55 62 21 43 99 19 56 58 76 52 49 40 76 51 50 18 76 33 40 39 41 48 22 24 76 42 25 23* 53 43 26 39 31 40 36 34 43 31 37 98 38 40 31 33 40 99 28 41 42 47 76 1 46 30 45 32 13 35 63 31 29 31 40 70 28 7 2 2 31 40 3 8 28 28 EXPLODED DRAWING—Model No.
LIMITED WARRANTY ICON OF CANADA INC., (ICON), warrants this product to be free from defects in workmanship and material, under normal use and service conditions, for a period of one (1) year from the date of purchase. This warranty extends only to the original purchaser. ICON's obligation under this warranty is limited to replacing or repairing, at ICON's option, the product at one of its authorized service centers.
